RE: [PATCH 1/2] mmc: rtsx: add delay before power on

[吳昊澄 Ricky]

> On Wed, 30 Dec 2020 at 10:04, <ricky_wu@xxxxxxxxxxx> wrote:
> >
> > From: Ricky Wu <ricky_wu@xxxxxxxxxxx>
> >
> > Make sure voltage below 0.5V before power on when do power cycle
> >
> > Signed-off-by: Ricky Wu <ricky_wu@xxxxxxxxxxx>
> > ---
> >  drivers/mmc/host/rtsx_pci_sdmmc.c | 2 ++
> >  1 file changed, 2 insertions(+)
> >
> > diff --git a/drivers/mmc/host/rtsx_pci_sdmmc.c
> > b/drivers/mmc/host/rtsx_pci_sdmmc.c
> > index e6f5bbce5685..d21b99962b36 100644
> > --- a/drivers/mmc/host/rtsx_pci_sdmmc.c
> > +++ b/drivers/mmc/host/rtsx_pci_sdmmc.c
> > @@ -906,6 +906,8 @@ static int sd_power_on(struct realtek_pci_sdmmc
> *host)
> >         if (host->power_state == SDMMC_POWER_ON)
> >                 return 0;
> >
> > +       mdelay(100);
> > +
> 
> Why exactly 100 ms? Can you at least add a comment about why in the code?
> 
> Moreover, I think you should convert to use msleep() rather than mdelay.
> 

Because we need to make sure voltage below 0.5V before power on
mmc-core will do quickly power cycle at recognition card phase, 
we need at least 100ms to make our device voltage below 0.5V 

I will change mdelay() to msleep()

> >         rtsx_pci_init_cmd(pcr);
> >         rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, CARD_SELECT, 0x07,
> SD_MOD_SEL);
> >         rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, CARD_SHARE_MODE,
> > --
> > 2.17.1
> >
> 
> Kind regards
> Uffe
> 
> ------Please consider the environment before printing this e-mail.