Re: [PATCH 2/4] dt-bindings: net: Add bindings for Qualcomm QCA807x

From: Rob Herring
Date: Sun Jan 03 2021 - 11:47:05 EST


On Wed, Dec 23, 2020 at 01:56:33AM +0100, Andrew Lunn wrote:
> > + gpio-controller: true
> > + "#gpio-cells":
> > + const: 2
> > +
> > + qcom,single-led-1000:
> > + description: |
> > + If present, then dedicated 1000 Mbit will light up for 1000Base-T.
> > + This is a workround for boards with a single LED instead of two.
> > + type: boolean
> > +
> > + qcom,single-led-100:
> > + description: |
> > + If present, then dedicated 1000 Mbit will light up for 100Base-TX.
> > + This is a workround for boards with a single LED instead of two.
> > + type: boolean
> > +
> > + qcom,single-led-10:
> > + description: |
> > + If present, then dedicated 1000 Mbit will light up for 10Base-Te.
> > + This is a workround for boards with a single LED instead of two.
> > + type: boolean
>
> Sorry, but no. Please look at the work being done for allow PHY LEDs
> to be controlled via the LED subsystem.
>
> > + qcom,tx-driver-strength:
> > + description: PSGMII/QSGMII TX driver strength control.
> > + $ref: /schemas/types.yaml#/definitions/uint32
> > + enum: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12]
>
> Please use the actual values here, and have the driver convert to the
> value poked into the register. So the property would be
> qcom,tx-driver-strength-mv and it would have the value 220 for
> example.

The LED binding has properties for specifying the current already. And
it's max current which is the h/w property where as anything less is
just software configuration (IOW, doesn't belong in DT).