Re: [PATCH 2/3] mac80211: Add support to trigger sta disconnect on hardware restart

From: Felix Fietkau
Date: Tue Dec 15 2020 - 12:42:07 EST



On 2020-12-15 18:23, Youghandhar Chintala wrote:
> Currently in case of target hardware restart, we just reconfig and
> re-enable the security keys and enable the network queues to start
> data traffic back from where it was interrupted.
>
> Many ath10k wifi chipsets have sequence numbers for the data
> packets assigned by firmware and the mac sequence number will
> restart from zero after target hardware restart leading to mismatch
> in the sequence number expected by the remote peer vs the sequence
> number of the frame sent by the target firmware.
>
> This mismatch in sequence number will cause out-of-order packets
> on the remote peer and all the frames sent by the device are dropped
> until we reach the sequence number which was sent before we restarted
> the target hardware
>
> In order to fix this, we trigger a sta disconnect, for the targets
> which expose this corresponding wiphy flag, in case of target hw
> restart. After this there will be a fresh connection and thereby
> avoiding the dropping of frames by remote peer.
>
> The right fix would be to pull the entire data path into the host
> which is not feasible or would need lots of complex changes and
> will still be inefficient.
How about simply tracking which tids have aggregation enabled and send
DELBA frames for those after the restart?
It would mean less disruption for affected stations and less ugly hacks
in the stack for unreliable hardware.

- Felix