Re: [PATCH] bcache: consider the fragmentation when update the writeback rate

From: Dongsheng Yang
Date: Tue Dec 08 2020 - 21:39:40 EST



在 2020/11/3 星期二 下午 8:42, Dongdong Tao 写道:
From: dongdong tao <dongdong.tao@xxxxxxxxxxxxx>

Current way to calculate the writeback rate only considered the
dirty sectors, this usually works fine when the fragmentation
is not high, but it will give us unreasonable small rate when
we are under a situation that very few dirty sectors consumed
a lot dirty buckets. In some case, the dirty bucekts can reached
to CUTOFF_WRITEBACK_SYNC while the dirty data(sectors) noteven
reached the writeback_percent, the writeback rate will still
be the minimum value (4k), thus it will cause all the writes to be
stucked in a non-writeback mode because of the slow writeback.

This patch will try to accelerate the writeback rate when the
fragmentation is high. It calculate the propotional_scaled value
based on below:
(dirty_sectors / writeback_rate_p_term_inverse) * fragment
As we can see, the higher fragmentation will result a larger
proportional_scaled value, thus cause a larger writeback rate.
The fragment value is calculated based on below:
(dirty_buckets * bucket_size) / dirty_sectors
If you think about it, the value of fragment will be always
inside [1, bucket_size].

This patch only considers the fragmentation when the number of
dirty_buckets reached to a dirty threshold(configurable by
writeback_fragment_percent, default is 50), so bcache will
remain the original behaviour before the dirty buckets reached
the threshold.

Signed-off-by: dongdong tao <dongdong.tao@xxxxxxxxxxxxx>
---
drivers/md/bcache/bcache.h | 1 +
drivers/md/bcache/sysfs.c | 6 ++++++
drivers/md/bcache/writeback.c | 21 +++++++++++++++++++++
3 files changed, 28 insertions(+)

diff --git a/drivers/md/bcache/bcache.h b/drivers/md/bcache/bcache.h
index 1d57f48307e6..87632f7032b6 100644
--- a/drivers/md/bcache/bcache.h
+++ b/drivers/md/bcache/bcache.h
@@ -374,6 +374,7 @@ struct cached_dev {
unsigned int writeback_metadata:1;
unsigned int writeback_running:1;
unsigned char writeback_percent;
+ unsigned char writeback_fragment_percent;
unsigned int writeback_delay;
uint64_t writeback_rate_target;
diff --git a/drivers/md/bcache/sysfs.c b/drivers/md/bcache/sysfs.c
index 554e3afc9b68..69499113aef8 100644
--- a/drivers/md/bcache/sysfs.c
+++ b/drivers/md/bcache/sysfs.c
@@ -115,6 +115,7 @@ rw_attribute(stop_when_cache_set_failed);
rw_attribute(writeback_metadata);
rw_attribute(writeback_running);
rw_attribute(writeback_percent);
+rw_attribute(writeback_fragment_percent);


Hi Dongdong and Coly,

    What is the status about this patch? In my opinion, it is a problem we need to solve,

but can we just reuse the parameter of writeback_percent, rather than introduce a new writeback_fragment_percent?

That means the semantic of writeback_percent will act on dirty data percent and dirty bucket percent.

When we found there are dirty buckets more than (c->nbuckets * writeback_percent), start the writeback.


Thanx

Yang

rw_attribute(writeback_delay);
rw_attribute(writeback_rate);
@@ -197,6 +198,7 @@ SHOW(__bch_cached_dev)
var_printf(writeback_running, "%i");
var_print(writeback_delay);
var_print(writeback_percent);
+ var_print(writeback_fragment_percent);
sysfs_hprint(writeback_rate,
wb ? atomic_long_read(&dc->writeback_rate.rate) << 9 : 0);
sysfs_printf(io_errors, "%i", atomic_read(&dc->io_errors));
@@ -308,6 +310,9 @@ STORE(__cached_dev)
sysfs_strtoul_clamp(writeback_percent, dc->writeback_percent,
0, bch_cutoff_writeback);
+ sysfs_strtoul_clamp(writeback_fragment_percent, dc->writeback_fragment_percent,
+ 0, bch_cutoff_writeback_sync);
+
if (attr == &sysfs_writeback_rate) {
ssize_t ret;
long int v = atomic_long_read(&dc->writeback_rate.rate);
@@ -498,6 +503,7 @@ static struct attribute *bch_cached_dev_files[] = {
&sysfs_writeback_running,
&sysfs_writeback_delay,
&sysfs_writeback_percent,
+ &sysfs_writeback_fragment_percent,
&sysfs_writeback_rate,
&sysfs_writeback_rate_update_seconds,
&sysfs_writeback_rate_i_term_inverse,
diff --git a/drivers/md/bcache/writeback.c b/drivers/md/bcache/writeback.c
index 3c74996978da..34babc89fdf3 100644
--- a/drivers/md/bcache/writeback.c
+++ b/drivers/md/bcache/writeback.c
@@ -88,6 +88,26 @@ static void __update_writeback_rate(struct cached_dev *dc)
int64_t integral_scaled;
uint32_t new_rate;
+ /*
+ * We need to consider the number of dirty buckets as well
+ * when calculating the proportional_scaled, Otherwise we might
+ * have an unreasonable small writeback rate at a highly fragmented situation
+ * when very few dirty sectors consumed a lot dirty buckets, the
+ * worst case is when dirty_data reached writeback_percent and
+ * dirty buckets reached to cutoff_writeback_sync, but the rate
+ * still will be at the minimum value, which will cause the write
+ * stuck at a non-writeback mode.
+ */
+ struct cache_set *c = dc->disk.c;
+
+ if (c->gc_stats.in_use > dc->writeback_fragment_percent && dirty > 0) {
+ int64_t dirty_buckets = (c->gc_stats.in_use * c->nbuckets) / 100;
+ int64_t fragment = (dirty_buckets * c->cache->sb.bucket_size) / dirty;
+
+ proportional_scaled =
+ div_s64(dirty, dc->writeback_rate_p_term_inverse) * (fragment);
+ }
+
if ((error < 0 && dc->writeback_rate_integral > 0) ||
(error > 0 && time_before64(local_clock(),
dc->writeback_rate.next + NSEC_PER_MSEC))) {
@@ -969,6 +989,7 @@ void bch_cached_dev_writeback_init(struct cached_dev *dc)
dc->writeback_metadata = true;
dc->writeback_running = false;
dc->writeback_percent = 10;
+ dc->writeback_fragment_percent = 50;
dc->writeback_delay = 30;
atomic_long_set(&dc->writeback_rate.rate, 1024);
dc->writeback_rate_minimum = 8;