[PATCH v1] gpio: dwapb: mask/unmask IRQ when disable/enable it

[Luo Jiaxing]

The mask and unmask registers are not configured in dwapb_irq_enable() and
dwapb_irq_disable(). In the following situations, the IRQ will be masked by
default after the IRQ is enabled:

mask IRQ -> disable IRQ -> enable IRQ

In this case, the IRQ status of GPIO controller is inconsistent with it's
irq_data too. For example, in __irq_enable(), IRQD_IRQ_DISABLED and
IRQD_IRQ_MASKED are both clear, but GPIO controller do not perform unmask.

Signed-off-by: Luo Jiaxing <luojiaxing@xxxxxxxxxx>
---
 drivers/gpio/gpio-dwapb.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/gpio/gpio-dwapb.c b/drivers/gpio/gpio-dwapb.c
index 2a9046c..ca654eb 100644
--- a/drivers/gpio/gpio-dwapb.c
+++ b/drivers/gpio/gpio-dwapb.c
@@ -270,6 +270,8 @@ static void dwapb_irq_enable(struct irq_data *d)
 	u32 val;
 
 	spin_lock_irqsave(&gc->bgpio_lock, flags);
+	val = dwapb_read(gpio, GPIO_INTMASK) & ~BIT(irqd_to_hwirq(d));
+	dwapb_write(gpio, GPIO_INTMASK, val);
 	val = dwapb_read(gpio, GPIO_INTEN);
 	val |= BIT(irqd_to_hwirq(d));
 	dwapb_write(gpio, GPIO_INTEN, val);
@@ -284,6 +286,8 @@ static void dwapb_irq_disable(struct irq_data *d)
 	u32 val;
 
 	spin_lock_irqsave(&gc->bgpio_lock, flags);
+	val = dwapb_read(gpio, GPIO_INTMASK) | BIT(irqd_to_hwirq(d));
+	dwapb_write(gpio, GPIO_INTMASK, val);
 	val = dwapb_read(gpio, GPIO_INTEN);
 	val &= ~BIT(irqd_to_hwirq(d));
 	dwapb_write(gpio, GPIO_INTEN, val);
-- 
2.7.4