Re: [PATCH v4 6/7] gpio: exar: switch to using regmap

[Andy Shevchenko]

On Tue, Nov 10, 2020 at 6:37 PM Bartosz Golaszewski
<bgolaszewski@xxxxxxxxxxxx> wrote:
> On Tue, Nov 10, 2020 at 5:17 PM Andy Shevchenko
> <andriy.shevchenko@xxxxxxxxxxxxxxx> wrote:

...

> > > > > > +static const struct regmap_config exar_regmap_config = {
> > > > > > +   .name           = "exar-gpio",
> > > > > > +   .reg_bits       = 16,
> > > > >
> > > > > As per previous version comment.
> > > > >
> > > > > Hold on, the registers are 16-bit wide, but their halves are sparsed!
> > > > > So, I guess 8 and 8 with helpers to get hi and lo parts are essential.
> > > > >
> > > > >
> > > > > TABLE 5: DEVICE CONFIGURATION REGISTERS SHOWN IN BYTE ALIGNMENT
> > > > >
> > > > > > +   .val_bits       = 8,
> > > > > > +};
> > > > >
> > > > > This is basically represents two banks out of 6 8-bit registers each.
> > > >
> > > > ...which makes me wonder if gpio-regmap can be utilized here...
> > > >
> > >
> > > But the address width won't affect the actuall accessing of 8 bits
> > > registers in an mmio regmap. Internally the mmio regmap does pretty
> > > much the same thing the previous driver did: call readb()/writeb() on
> > > 8-bit "chunks" of the banks.
> >
> > It will affect reg dump in debugfs. I would really narrow down the register
> > address space in the config, otherwise that debugfs facility will screw up a
> > lot of things.
> >
> > So, and to be on pedantic side...
> >
> > "The Device Configuration Registers and the two individual UART Configuration
> > Registers of the XR17V352 occupy 2K of PCI bus memory address space."
> >
> > 11 seems the correct value for the address width.
>
> I take it as a typo and assume you meant 16. So the patch should be
> correct and your review tag is good to go?

It's not a typo. But thinking again. This is basically done in regmap
to support serial buses. Here we have MMIO pretty much with 32-bit or
64-bit address accesses. I didn't dig into regmap implementation to
understand the consequences of changing this to the different values
(it seems like rather offset, and in this case 11 is a correct one,
not a typo, and regmap is okay with that).
But I would rather ask Jan to actually mount debugfs and dump
registers and see if it screws up the UART (because it may go all over
important registers), that's why I think this configuration is still
missing some strict rules about what addresses (offsets) driver may or
may not access.



-- 
With Best Regards,
Andy Shevchenko