Re: [PATCH v4 6/7] gpio: exar: switch to using regmap

[Andy Shevchenko]

On Tue, Nov 10, 2020 at 04:12:38PM +0100, Bartosz Golaszewski wrote:
> On Tue, Nov 10, 2020 at 4:09 PM Andy Shevchenko
> <andriy.shevchenko@xxxxxxxxxxxxxxx> wrote:
> >
> > On Tue, Nov 10, 2020 at 05:04:47PM +0200, Andy Shevchenko wrote:
> > > On Tue, Nov 10, 2020 at 03:55:51PM +0100, Bartosz Golaszewski wrote:
> > > > From: Bartosz Golaszewski <bgolaszewski@xxxxxxxxxxxx>
> > > >
> > > > We can simplify the code in gpio-exar by using regmap. This allows us to
> > > > drop the mutex (regmap provides its own locking) and we can also reuse
> > > > regmap's bit operations instead of implementing our own update function.
> > >
> > > ...
> > >
> > > > +static const struct regmap_config exar_regmap_config = {
> > > > +   .name           = "exar-gpio",
> > > > +   .reg_bits       = 16,
> > >
> > > As per previous version comment.
> > >
> > > Hold on, the registers are 16-bit wide, but their halves are sparsed!
> > > So, I guess 8 and 8 with helpers to get hi and lo parts are essential.
> > >
> > >
> > > TABLE 5: DEVICE CONFIGURATION REGISTERS SHOWN IN BYTE ALIGNMENT
> > >
> > > > +   .val_bits       = 8,
> > > > +};
> > >
> > > This is basically represents two banks out of 6 8-bit registers each.
> >
> > ...which makes me wonder if gpio-regmap can be utilized here...
> >
> 
> But the address width won't affect the actuall accessing of 8 bits
> registers in an mmio regmap. Internally the mmio regmap does pretty
> much the same thing the previous driver did: call readb()/writeb() on
> 8-bit "chunks" of the banks.

It will affect reg dump in debugfs. I would really narrow down the register
address space in the config, otherwise that debugfs facility will screw up a
lot of things.

So, and to be on pedantic side...

"The Device Configuration Registers and the two individual UART Configuration
Registers of the XR17V352 occupy 2K of PCI bus memory address space."

11 seems the correct value for the address width.

-- 
With Best Regards,
Andy Shevchenko