Re: [PATCH v3 2/2] usb: phy: Add USB3 PHY support for Intel LGM SoC

[Andy Shevchenko]

On Fri, Jun 12, 2020 at 10:59:41AM +0800, Ramuthevar,Vadivel MuruganX wrote:
> From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx>
> 
> Add support for USB PHY on Intel LGM SoC.

Thank you for an update, looks pretty much good, my comments below.

...

> +static int get_flipped(struct tca_apb *ta, bool *flipped)
> +{
> +	union extcon_property_value property;
> +	int ret;
> +
> +	ret = extcon_get_property(ta->phy.edev, EXTCON_USB_HOST,
> +				  EXTCON_PROP_USB_TYPEC_POLARITY, &property);
> +	if (ret) {

> +		dev_err(ta->phy.dev, "no polarity property from extcon\n");

(1)

> +		return ret;
> +	}
> +
> +	*flipped = property.intval;
> +
> +	return ret;
> +}

...

> +	ret = get_flipped(ta, &flipped);
> +	if (ret)
> +		dev_err(ta->phy.dev, "no polarity property from extcon\n");

You already has a message in (1). You should decide which one to leave.

But note, if it's a fatal error, you have to return here, otherwise, if you
decide to leave message here, it should be not on error level.

> +	connected = extcon_get_state(ta->phy.edev, EXTCON_USB_HOST);
> +	if (connected == ta->connected)
> +		return;
> +
> +	ta->connected = connected;
> +	if (connected) {
> +		val = TCPC_VALID | FIELD_PREP(TCPC_MUX_CTL, MUX_USB);
> +		if (flipped)
> +			val |= TCPC_FLIPPED;
> +		dev_info(ta->phy.dev, "connected%s\n", flipped ? " flipped" : "");
> +	} else {
> +		val = TCPC_DISCONN;
> +		dev_info(ta->phy.dev, "disconnected\n");
> +	}
> +
> +	writel(val, ta->phy.io_priv + TCPC_OFFSET);
> +

> +	if (ta->phy.set_vbus(&ta->phy, connected))
> +		dev_err(ta->phy.dev, "failed to set VBUS\n");

Please, split it to
	ret = ...;
	if (ret)

> +}

...

> +static int vbus_notifier(struct notifier_block *nb,
> +			 unsigned long event, void *ptr)

Consider to put it on one line (you can also shrink the names of unused
parameters.

> +{
> +	return NOTIFY_DONE;
> +}

-- 
With Best Regards,
Andy Shevchenko