[PATCH v2 0/2] usb : phy: Add USB PHY support on Intel LGM SoC

[Ramuthevar,Vadivel MuruganX]

The USB PHY provides the optimized for low power dissipation while active, idle, or on standby.
Requires minimal external components, a single resistor, for best operation.
Supports 10/5-Gbps high-speed data transmission rates through 3-m USB 3.x cable 
---
v2:
  - Address Phillip's review comments
  - replace devm_reset_control_get() by devm_reset_control_get_exclusive()
  - re-design the assert and deassert fucntion calls as per review comments
  - address kbuild bot warnings
  - add the comments 
v1:
  - initial version

---
dt-bindings: usb: Add USB PHY support for Intel LGM SoC
v2:
  - No Change
v1:
  - initial version


Ramuthevar Vadivel Murugan (2):
  dt-bindings: usb: Add USB PHY support for Intel LGM SoC
  usb: phy: Add USB3 PHY support for Intel LGM SoC

 .../devicetree/bindings/usb/intel,lgm-usb-phy.yaml |  53 ++++
 drivers/usb/phy/Kconfig                            |  11 +
 drivers/usb/phy/Makefile                           |   1 +
 drivers/usb/phy/phy-lgm-usb.c                      | 280 +++++++++++++++++++++
 4 files changed, 345 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/intel,lgm-usb-phy.yaml
 create mode 100644 drivers/usb/phy/phy-lgm-usb.c

-- 
2.11.0