[PATCH 11/19] staging: wfx: request to send beacons in IBSS mode

[Jerome Pouiller]

From: JÃrÃme Pouiller <jerome.pouiller@xxxxxxxxxx>

Currently, firmware take in charge of start/stop sending beacons while
in IBSS mode. However, this behavior may change in the further releases.

Currently, asking to firmware to send beacon while in IBSS mode return
an error but is harmless.

Therefore, send this request unconditionally.

Signed-off-by: JÃrÃme Pouiller <jerome.pouiller@xxxxxxxxxx>
---
 drivers/staging/wfx/sta.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/drivers/staging/wfx/sta.c b/drivers/staging/wfx/sta.c
index 7af7bfa4ac99..3512e59f0968 100644
--- a/drivers/staging/wfx/sta.c
+++ b/drivers/staging/wfx/sta.c
@@ -697,8 +697,7 @@ void wfx_bss_info_changed(struct ieee80211_hw *hw,
 	    changed & BSS_CHANGED_BEACON)
 		wfx_upload_ap_templates(wvif);
 
-	if (changed & BSS_CHANGED_BEACON_ENABLED &&
-	    wvif->state != WFX_STATE_IBSS)
+	if (changed & BSS_CHANGED_BEACON_ENABLED)
 		wfx_enable_beacon(wvif, info->enable_beacon);
 
 	if (changed & BSS_CHANGED_BEACON_INFO)
-- 
2.25.1