Re: [PATCH 02/21] tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state

[Jun Nie]

> > @@ -961,7 +962,7 @@ static void qcom_geni_serial_set_termios(struct uart_port *uport,
> >               goto out_restart_rx;
> >
> >       uport->uartclk = clk_rate;
> > -     clk_set_rate(port->se.clk, clk_rate);
> > +     dev_pm_opp_set_rate(uport->dev, clk_rate);

Hi Rajendra,

I see lowest rpmhpd_opp_low_svs opp is for 75MHz. It is a bit higher
for a serial.
I am just curious about this.

I also want to confirm that the rpmhpd_opp_low_svs voltage restriction
is for serial
controller, not for clock controller? Because I see there is similar
restriction to clock
controller on another platform, the restriction is for branch clock,
not leaf clock that
consumer device will get.

Jun