RE: [PATCH] tty: samsung_tty: 32-bit access for TX/RX hold registers

From: Hyunki Koo
Date: Thu Apr 02 2020 - 05:45:09 EST


On Wed, Apr 01, 2020 at 6:20:20PM +0900, Krzysztof Kozlowski
wrote:
> On Wed, Apr 01, 2020 at 10:55:48AM +0200, Greg Kroah-Hartman
> wrote:
> > On Wed, Apr 01, 2020 at 05:27:20PM +0900, Hyunki Koo wrote:
> > > - if (np)
> > > + if (np) {
> > > of_property_read_u32(np,
> > > "samsung,uart-fifosize", &ourport->port.fifosize);
> > >
> > > + if (of_property_read_u32(np, "reg-io-width", &prop) ==
> 0) {
> > > + switch (prop) {
> > > + case 1:
> > > + ourport->port.iotype = UPIO_MEM;
> > > + break;
> > > + case 4:
> > > + ourport->port.iotype = UPIO_MEM32;
> > > + break;
> > > + default:
> > > + dev_warn(&pdev->dev, "unsupported
> reg-io-width (%d)\n",
> > > + prop);
> > > + ret = -EINVAL;
> > > + break;
> > > + }
> > > + }
> > > + }
> > > +
> >
> > Does this mean that reg-io-width is now a required property for all
> > samsung uarts? Does this break older dts files? Or should you
> > fall-back to the previous operation if the attribute is not there?
>
> Yes, it looks like silently breaking all boards. Since
> of_property_read_u32() will return errno, the warning message won't be
> printed and all register reads will fail (return 0).
>
> This looks like not tested on real HW.
>
> Best regards,
> Krzysztof

[Hyunki Koo]
reg-io-width =4 is required for Samsung uart
To do not break older dts files, I will set default value in else of of_property_read_u32 like below.
+ if (of_property_read_u32(np, "reg-io-width", &prop) == 0) {
+ ...
+ } else {
+ ourport->port.iotype = UPIO_MEM;
+ }