[PATCH v7 02/12] MIPS: DTS: CI20: add DT node for IR sensor

[Jiaxun Yang]

From: Alex Smith <alex.smith@xxxxxxxxxx>

The infrared sensor on the CI20 board is connected to a GPIO and can
be operated by using the gpio-ir-recv driver. Add a DT node for the
sensor to allow that driver to be used.

Signed-off-by: Alex Smith <alex.smith@xxxxxxxxxx>
Signed-off-by: H. Nikolaus Schaller <hns@xxxxxxxxxxxxx>
Reviewed-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
Signed-off-by: Thomas Bogendoerfer <tsbogend@xxxxxxxxxxxxxxxx>
---
 arch/mips/boot/dts/ingenic/ci20.dts | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/mips/boot/dts/ingenic/ci20.dts b/arch/mips/boot/dts/ingenic/ci20.dts
index c340f947baa0..fc4e64200c3d 100644
--- a/arch/mips/boot/dts/ingenic/ci20.dts
+++ b/arch/mips/boot/dts/ingenic/ci20.dts
@@ -62,6 +62,11 @@ eth0_power: fixedregulator@0 {
 		enable-active-high;
 	};
 
+	ir: ir {
+		compatible = "gpio-ir-receiver";
+		gpios = <&gpe 3 GPIO_ACTIVE_LOW>;
+	};
+
 	wlan0_power: fixedregulator@1 {
 		compatible = "regulator-fixed";
 		regulator-name = "wlan0_power";
-- 
2.26.0.rc2