Re: [PATCH net-next v6 08/10] net: phy: use phy_read_poll_timeout() to simplify the code

[Florian Fainelli]

On 3/22/2020 7:56 PM, Dejin Zheng wrote:
> use phy_read_poll_timeout() to replace the poll codes for
> simplify the code in phy_poll_reset() function.
> 
> Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
> Signed-off-by: Dejin Zheng <zhengdejin5@xxxxxxxxx>
> ---
> v5 -> v6:
> 	- add some check for keep the code more similar.
> v4 -> v5:
> 	- it can add msleep before call phy_read_poll_timeout()
> 	  to keep the code more similar. so add it.
> v3 -> v4:
> 	- drop it.
> v2 -> v3:
> 	- adapt to it after modifying the parameter order of the
> 	  newly added function
> v1 -> v2:
> 	- remove the handle of phy_read()'s return error.
> 
>  drivers/net/phy/phy_device.c | 17 ++++++-----------
>  1 file changed, 6 insertions(+), 11 deletions(-)
> 
> diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
> index a585faf8b844..eb1b177a9878 100644
> --- a/drivers/net/phy/phy_device.c
> +++ b/drivers/net/phy/phy_device.c
> @@ -1059,18 +1059,13 @@ EXPORT_SYMBOL(phy_disconnect);
>  static int phy_poll_reset(struct phy_device *phydev)
>  {
>  	/* Poll until the reset bit clears (50ms per retry == 0.6 sec) */
> -	unsigned int retries = 12;
> -	int ret;
> -
> -	do {
> -		msleep(50);
> -		ret = phy_read(phydev, MII_BMCR);
> -		if (ret < 0)
> -			return ret;
> -	} while (ret & BMCR_RESET && --retries);
> -	if (ret & BMCR_RESET)
> -		return -ETIMEDOUT;
> +	int ret, val;
>  
> +	msleep(50);
> +	ret = phy_read_poll_timeout(phydev, MII_BMCR, val, !(val & BMCR_RESET),
> +				    50000, 550000);
> +	if (ret)
> +		return ret;

You may consider creating a special variant of phy_read_poll_timeout()
which sleeps before checking the condition, since there are at least two
occurrences of this here and within marvell10g.c?
-- 
Florian