[PATCH 5.4 427/434] mmc: sdhci-msm: Correct the offset and value for DDR_CONFIG register

From: Greg Kroah-Hartman
Date: Sun Dec 29 2019 - 12:58:30 EST


From: Veerabhadrarao Badiganti <vbadigan@xxxxxxxxxxxxxx>

commit fa56ac9792265354b565f28def7164e7d7db2b1e upstream.

The DDR_CONFIG register offset got updated after a specific
minor version of sdcc V4. This offset change has not been properly
taken care of while updating register changes for sdcc V5.

Correcting proper offset for this register.
Also updating this register value to reflect the recommended RCLK
delay.

Signed-off-by: Veerabhadrarao Badiganti <vbadigan@xxxxxxxxxxxxxx>
Link: https://lore.kernel.org/r/0101016ea738ec72-fa0f852d-20f8-474a-80b2-4b0ef63b132c-000000@xxxxxxxxxxxxxxxxxxxxxxx
Fixes: f15358885dda ("mmc: sdhci-msm: Define new Register address map")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>

---
drivers/mmc/host/sdhci-msm.c | 28 +++++++++++++++++++---------
1 file changed, 19 insertions(+), 9 deletions(-)

--- a/drivers/mmc/host/sdhci-msm.c
+++ b/drivers/mmc/host/sdhci-msm.c
@@ -99,7 +99,7 @@

#define CORE_PWRSAVE_DLL BIT(3)

-#define DDR_CONFIG_POR_VAL 0x80040853
+#define DDR_CONFIG_POR_VAL 0x80040873


#define INVALID_TUNING_PHASE -1
@@ -148,8 +148,9 @@ struct sdhci_msm_offset {
u32 core_ddr_200_cfg;
u32 core_vendor_spec3;
u32 core_dll_config_2;
+ u32 core_dll_config_3;
+ u32 core_ddr_config_old; /* Applicable to sdcc minor ver < 0x49 */
u32 core_ddr_config;
- u32 core_ddr_config_2;
};

static const struct sdhci_msm_offset sdhci_msm_v5_offset = {
@@ -177,8 +178,8 @@ static const struct sdhci_msm_offset sdh
.core_ddr_200_cfg = 0x224,
.core_vendor_spec3 = 0x250,
.core_dll_config_2 = 0x254,
- .core_ddr_config = 0x258,
- .core_ddr_config_2 = 0x25c,
+ .core_dll_config_3 = 0x258,
+ .core_ddr_config = 0x25c,
};

static const struct sdhci_msm_offset sdhci_msm_mci_offset = {
@@ -207,8 +208,8 @@ static const struct sdhci_msm_offset sdh
.core_ddr_200_cfg = 0x184,
.core_vendor_spec3 = 0x1b0,
.core_dll_config_2 = 0x1b4,
- .core_ddr_config = 0x1b8,
- .core_ddr_config_2 = 0x1bc,
+ .core_ddr_config_old = 0x1b8,
+ .core_ddr_config = 0x1bc,
};

struct sdhci_msm_variant_ops {
@@ -253,6 +254,7 @@ struct sdhci_msm_host {
const struct sdhci_msm_offset *offset;
bool use_cdr;
u32 transfer_mode;
+ bool updated_ddr_cfg;
};

static const struct sdhci_msm_offset *sdhci_priv_msm_offset(struct sdhci_host *host)
@@ -924,8 +926,10 @@ out:
static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host)
{
struct mmc_host *mmc = host->mmc;
- u32 dll_status, config;
+ u32 dll_status, config, ddr_cfg_offset;
int ret;
+ struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+ struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host);
const struct sdhci_msm_offset *msm_offset =
sdhci_priv_msm_offset(host);

@@ -938,8 +942,11 @@ static int sdhci_msm_cm_dll_sdc4_calibra
* bootloaders. In the future, if this changes, then the desired
* values will need to be programmed appropriately.
*/
- writel_relaxed(DDR_CONFIG_POR_VAL, host->ioaddr +
- msm_offset->core_ddr_config);
+ if (msm_host->updated_ddr_cfg)
+ ddr_cfg_offset = msm_offset->core_ddr_config;
+ else
+ ddr_cfg_offset = msm_offset->core_ddr_config_old;
+ writel_relaxed(DDR_CONFIG_POR_VAL, host->ioaddr + ddr_cfg_offset);

if (mmc->ios.enhanced_strobe) {
config = readl_relaxed(host->ioaddr +
@@ -1899,6 +1906,9 @@ static int sdhci_msm_probe(struct platfo
msm_offset->core_vendor_spec_capabilities0);
}

+ if (core_major == 1 && core_minor >= 0x49)
+ msm_host->updated_ddr_cfg = true;
+
/*
* Power on reset state may trigger power irq if previous status of
* PWRCTL was either BUS_ON or IO_HIGH_V. So before enabling pwr irq