[PATCH 0/7] towards QE support on ARM

[Rasmus Villemoes]

There have been several attempts in the past few years to allow
building the QUICC engine drivers for platforms other than PPC. This
is (the beginning of) yet another attempt. I hope I can get someone to
pick up these relatively trivial patches (I _think_ they shouldn't
change functionality at all), and then I'll continue slowly working
towards removing the PPC32 dependency for CONFIG_QUICC_ENGINE.

Tested on an MPC8309-derived board.

Rasmus Villemoes (7):
  soc: fsl: qe: remove space-before-tab
  soc: fsl: qe: drop volatile qualifier of struct qe_ic::regs
  soc: fsl: qe: avoid ppc-specific io accessors
  soc: fsl: qe: replace spin_event_timeout by readx_poll_timeout_atomic
  serial: make SERIAL_QE depend on PPC32
  serial: ucc_uart.c: explicitly include asm/cpm.h
  soc/fsl/qe/qe.h: remove include of asm/cpm.h

 drivers/soc/fsl/qe/gpio.c     | 30 ++++++++--------
 drivers/soc/fsl/qe/qe.c       | 44 +++++++++++------------
 drivers/soc/fsl/qe/qe_ic.c    |  8 ++---
 drivers/soc/fsl/qe/qe_ic.h    |  2 +-
 drivers/soc/fsl/qe/qe_io.c    | 40 ++++++++++-----------
 drivers/soc/fsl/qe/qe_tdm.c   |  8 ++---
 drivers/soc/fsl/qe/ucc.c      | 12 +++----
 drivers/soc/fsl/qe/ucc_fast.c | 66 ++++++++++++++++++-----------------
 drivers/soc/fsl/qe/ucc_slow.c | 38 ++++++++++----------
 drivers/soc/fsl/qe/usb.c      |  2 +-
 drivers/tty/serial/Kconfig    |  1 +
 drivers/tty/serial/ucc_uart.c |  1 +
 include/soc/fsl/qe/qe.h       |  1 -
 13 files changed, 126 insertions(+), 127 deletions(-)

-- 
2.20.1