[PATCH v2 0/5] add dsa switch support for ar9331

From: Oleksij Rempel
Date: Fri Oct 18 2019 - 05:39:55 EST


changes v2:
- move Atheros AR9331 TAG format to separate patch
- use netdev_warn_once in the tag driver to reduce potential message spam
- typo fixes
- reorder tag driver alphabetically
- configure switch to maximal frame size
- use mdiobus_read/write
- fail if mdio sub node is not found
- add comment for post reset state
- remove deprecated comment about device id
- remove phy-handle option for node with fixed-link
- ag71xx: set 1G support only for GMII mode

This patch series provides dsa switch support for Atheros ar9331 WiSoC.
As side effect ag71xx needed to be ported to phylink to make the switch
driver (as well phylink based) work properly.

Oleksij Rempel (5):
net: ag71xx: port to phylink
dt-bindings: net: dsa: qca,ar9331 switch documentation
MIPS: ath79: ar9331: add ar9331-switch node
net: dsa: add support for Atheros AR9331 TAG format
net: dsa: add support for Atheros AR9331 build-in switch

.../devicetree/bindings/net/dsa/ar9331.txt | 148 ++++
arch/mips/boot/dts/qca/ar9331.dtsi | 127 ++-
arch/mips/boot/dts/qca/ar9331_dpt_module.dts | 13 +
drivers/net/dsa/Kconfig | 2 +
drivers/net/dsa/Makefile | 1 +
drivers/net/dsa/qca/Kconfig | 11 +
drivers/net/dsa/qca/Makefile | 2 +
drivers/net/dsa/qca/ar9331.c | 823 ++++++++++++++++++
drivers/net/ethernet/atheros/Kconfig | 2 +-
drivers/net/ethernet/atheros/ag71xx.c | 146 ++--
include/net/dsa.h | 2 +
net/dsa/Kconfig | 6 +
net/dsa/Makefile | 1 +
net/dsa/tag_ar9331.c | 97 +++
14 files changed, 1319 insertions(+), 62 deletions(-)
create mode 100644 Documentation/devicetree/bindings/net/dsa/ar9331.txt
create mode 100644 drivers/net/dsa/qca/Kconfig
create mode 100644 drivers/net/dsa/qca/Makefile
create mode 100644 drivers/net/dsa/qca/ar9331.c
create mode 100644 net/dsa/tag_ar9331.c

--
2.23.0