Re: [PATCH] erspan: remove the incorrect mtu limit for erspan

From: William Tu
Date: Thu Oct 03 2019 - 14:30:04 EST


On Thu, Sep 26, 2019 at 11:59 PM Haishuang Yan
<yanhaishuang@xxxxxxxxxxxxxxxxxxxx> wrote:
>
> erspan driver calls ether_setup(), after commit 61e84623ace3
> ("net: centralize net_device min/max MTU checking"), the range
> of mtu is [min_mtu, max_mtu], which is [68, 1500] by default.
>
> It causes the dev mtu of the erspan device to not be greater
> than 1500, this limit value is not correct for ipgre tap device.
>
> Tested:
> Before patch:
> # ip link set erspan0 mtu 1600
> Error: mtu greater than device maximum.
> After patch:
> # ip link set erspan0 mtu 1600
> # ip -d link show erspan0
> 21: erspan0@NONE: <BROADCAST,MULTICAST> mtu 1600 qdisc noop state DOWN
> mode DEFAULT group default qlen 1000
> link/ether 00:00:00:00:00:00 brd ff:ff:ff:ff:ff:ff promiscuity 0 minmtu 68 maxmtu 0
>
> Fixes: 61e84623ace3 ("net: centralize net_device min/max MTU checking")
> Signed-off-by: Haishuang Yan <yanhaishuang@xxxxxxxxxxxxxxxxxxxx>
> ---

Thanks for the patch!
Acked-by: William Tu <u9012063@xxxxxxxxx>


> net/ipv4/ip_gre.c | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/net/ipv4/ip_gre.c b/net/ipv4/ip_gre.c
> index a53a543..52690bb 100644
> --- a/net/ipv4/ip_gre.c
> +++ b/net/ipv4/ip_gre.c
> @@ -1446,6 +1446,7 @@ static void erspan_setup(struct net_device *dev)
> struct ip_tunnel *t = netdev_priv(dev);
>
> ether_setup(dev);
> + dev->max_mtu = 0;
> dev->netdev_ops = &erspan_netdev_ops;
> dev->priv_flags &= ~IFF_TX_SKB_SHARING;
> dev->priv_flags |= IFF_LIVE_ADDR_CHANGE;
> --
> 1.8.3.1
>
>
>