[PATCH 3/4 v2] w1: ds2413: when the slave is not responding during read, select it again

[Mariusz Bialonczyk]

The protocol is not allowing to obtain a byte of 0xff for PIO_ACCESS_READ
call. It is very likely that the slave was not addressed properly and
it is just not respoding (leaving the bus in logic high state) during
the read of sampled PIO value.
We cannot just call w1_reset_resume_command() because the problem will
persist, instead try selecting (addressing) the slave again.

Signed-off-by: Mariusz Bialonczyk <manio@xxxxxxxxxx>
---
Changes in v2:
    Optimize the if statement so the most common is checked first.

 drivers/w1/slaves/w1_ds2413.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/w1/slaves/w1_ds2413.c b/drivers/w1/slaves/w1_ds2413.c
index d63778c70568..21f08ac8a4e0 100644
--- a/drivers/w1/slaves/w1_ds2413.c
+++ b/drivers/w1/slaves/w1_ds2413.c
@@ -24,6 +24,7 @@
 #define W1_F3A_FUNC_PIO_ACCESS_READ        0xF5
 #define W1_F3A_FUNC_PIO_ACCESS_WRITE       0x5A
 #define W1_F3A_SUCCESS_CONFIRM_BYTE        0xAA
+#define W1_F3A_INVALID_PIO_STATE           0xFF
 
 static ssize_t state_read(struct file *filp, struct kobject *kobj,
 			  struct bin_attribute *bin_attr, char *buf, loff_t off,
@@ -45,6 +46,7 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj,
 	mutex_lock(&sl->master->bus_mutex);
 	dev_dbg(&sl->dev, "mutex locked");
 
+next:
 	if (w1_reset_select_slave(sl))
 		goto out;
 
@@ -52,10 +54,15 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj,
 		w1_write_8(sl->master, W1_F3A_FUNC_PIO_ACCESS_READ);
 
 		*buf = w1_read_8(sl->master);
-		/* check for correct complement */
 		if ((*buf & 0x0F) == ((~*buf >> 4) & 0x0F)) {
+			/* complement is correct */
 			bytes_read = 1;
 			goto out;
+		} else if (*buf == W1_F3A_INVALID_PIO_STATE) {
+			/* slave didn't respond, try to select it again */
+			dev_warn(&sl->dev, "slave device did not respond to PIO_ACCESS_READ, " \
+					    "reselecting, retries left: %d\n", retries);
+			goto next;
 		}
 
 		if (w1_reset_resume_command(sl->master))
-- 
2.19.0.rc1