Re: [PATCH 1/3] rtc: s35390a: clarify INT2 pin output modes

[Richard Leitner]

On 21/05/2019 17:54, Alexandre Belloni wrote:
> Hello,
>
> This seems good to me but...
>
> On 21/05/2019 16:20:22+0200, Richard Leitner wrote:

> > --- a/drivers/rtc/rtc-s35390a.c
> > +++ b/drivers/rtc/rtc-s35390a.c
> > @@ -45,12 +45,13 @@
> >   /* flag for STATUS2 */
> >   #define S35390A_FLAG_TEST	0x01
> >   
> > -#define S35390A_INT2_MODE_MASK		0xF0
> > -
> > +/* INT2 pin output mode */
> > +#define S35390A_INT2_MODE_MASK		0x0E
> >   #define S35390A_INT2_MODE_NOINTR	0x00
> > -#define S35390A_INT2_MODE_FREQ		0x10
> > -#define S35390A_INT2_MODE_ALARM		0x40
> > -#define S35390A_INT2_MODE_PMIN_EDG	0x20
> > +#define S35390A_INT2_MODE_ALARM		0x02 /* INT2AE */
> > +#define S35390A_INT2_MODE_PMIN_EDG	0x04 /* INT2ME */
> > +#define S35390A_INT2_MODE_FREQ		0x08 /* INT2FE */
> > +#define S35390A_INT2_MODE_PMIN		0x0C /* INT2ME | INT2FE */
> >   
>
> While you are at it you may as well use BIT().

Sure, will change that for v2.

regards;Richard.L