Re: [EXT] Re: [PATCH 2/3] arm64: dts: ls1028a: Add PCIe controller DT nodes

[Arnd Bergmann]

On Fri, May 17, 2019 at 5:21 AM Xiaowei Bao <xiaowei.bao@xxxxxxx> wrote:
> -----Original Message-----
> From: Arnd Bergmann <arnd@xxxxxxxx>
> On Wed, May 15, 2019 at 9:36 AM Xiaowei Bao <xiaowei.bao@xxxxxxx> wrote:
> > Signed-off-by: Xiaowei Bao <xiaowei.bao@xxxxxxx>
> > ---
> >  arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi |   52 ++++++++++++++++++++++++
> >  1 files changed, 52 insertions(+), 0 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> > index b045812..50b579b 100644
> > --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> > +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> > @@ -398,6 +398,58 @@
> >                         status = "disabled";
> >                 };
> >
> > +               pcie@3400000 {
> > +                       compatible = "fsl,ls1028a-pcie";
> > +                       reg = <0x00 0x03400000 0x0 0x00100000   /* controller registers */
> > +                              0x80 0x00000000 0x0 0x00002000>; /* configuration space */
> > +                       reg-names = "regs", "config";
> > +                       interrupts = <GIC_SPI 108 IRQ_TYPE_LEVEL_HIGH>, /* PME interrupt */
> > +                                    <GIC_SPI 109 IRQ_TYPE_LEVEL_HIGH>; /* aer interrupt */
> > +                       interrupt-names = "pme", "aer";
> > +                       #address-cells = <3>;
> > +                       #size-cells = <2>;
> > +                       device_type = "pci";
> > +                       dma-coherent;
> > +                       num-lanes = <4>;
> > +                       bus-range = <0x0 0xff>;
> > +                       ranges = <0x81000000 0x0 0x00000000 0x80 0x00010000 0x0 0x00010000   /* downstream I/O */
> > +                                 0x82000000 0x0 0x40000000 0x80 0x40000000 0x0 0x40000000>; /* non-prefetchable memory */
>
> Are you sure there is no support for 64-bit BARs or prefetchable memory?
> [Xiaowei Bao] sorry for late reply, Thought that our Layerscape platform has not added prefetchable memory support in DTS, so this platform has not been added, I will submit a separate patch to add prefetchable memory support for all Layerscape platforms.

Ok, thanks.

> Of course, the prefetchable PCIE device can work in our boards, because the RC will
> assign non-prefetchable memory for this device. We reserve 1G no-prefetchable
> memory for PCIE device, it is enough for general devices.

Sure, many devices work just fine, this is mostly a question of supporting those
devices that do require multiple gigabytes, or that need prefetchable memory
semantics to get the expected performance. GPUs are the obvious example,
but I think there are others (infiniband?).

      Arnd