[PATCH v2 4/5] OPP: Update the bandwidth on OPP frequency changes

[Georgi Djakov]

If the OPP bandwidth values are populated, we want to switch also the
interconnect bandwidth in addition to frequency and voltage.

Signed-off-by: Georgi Djakov <georgi.djakov@xxxxxxxxxx>
---
 drivers/opp/core.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/opp/core.c b/drivers/opp/core.c
index 97ee39ecdebd..91d1c2abfb3e 100644
--- a/drivers/opp/core.c
+++ b/drivers/opp/core.c
@@ -707,7 +707,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
 	unsigned long freq, old_freq;
 	struct dev_pm_opp *old_opp, *opp;
 	struct clk *clk;
-	int ret;
+	int ret, i;
 
 	if (unlikely(!target_freq)) {
 		dev_err(dev, "%s: Invalid target frequency %lu\n", __func__,
@@ -780,6 +780,13 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
 		ret = _generic_set_opp_clk_only(dev, clk, freq);
 	}
 
+	if (!ret && !IS_ERR_OR_NULL(opp_table->paths)) {
+		for (i = 0; i < opp_table->path_count; i++) {
+			icc_set_bw(opp_table->paths[i], opp->bandwidth[i].avg,
+				   opp->bandwidth[i].peak);
+		}
+	}
+
 	/* Scaling down? Configure required OPPs after frequency */
 	if (!ret && freq < old_freq) {
 		ret = _set_required_opps(dev, opp_table, opp);