Re: [PATCH net-next] net: dsa: Do not configure VLAN ID 0

[Heiner Kallweit]

On 01.03.2019 00:49, Florian Fainelli wrote:
> Because we skip the prepare phase, we would not get a chance to have the
> port_vlan_prepare() callback return -EOPNOTSUPP and tell us about that.
> This causes problems with mv88e6xxx which specifically checks for VLAN
> ID = 0. Turns out we do not actually need to program that VLAN ID since
> it should be the default one for switches anyway.
> 
> Reported-by: Heiner Kallweit <hkallweit1@xxxxxxxxx>
> Fixes: 061f6a505ac3 ("net: dsa: Add ndo_vlan_rx_{add, kill}_vid implementation")
> Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
> ---
>  net/dsa/slave.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/net/dsa/slave.c b/net/dsa/slave.c
> index 1808a2cd6872..ec54d579645a 100644
> --- a/net/dsa/slave.c
> +++ b/net/dsa/slave.c
> @@ -996,6 +996,9 @@ static int dsa_slave_vlan_rx_add_vid(struct net_device *dev, __be16 proto,
>  	struct bridge_vlan_info info;
>  	int ret;
>  
> +	if (vid == 0)
> +		return 0;
> +
>  	/* Check for a possible bridge VLAN entry now since there is no
>  	 * need to emulate the switchdev prepare + commit phase.
>  	 */
> @@ -1029,6 +1032,9 @@ static int dsa_slave_vlan_rx_kill_vid(struct net_device *dev, __be16 proto,
>  	struct bridge_vlan_info info;
>  	int ret;
>  
> +	if (vid == 0)
> +		return 0;
> +
>  	/* Check for a possible bridge VLAN entry now since there is no
>  	 * need to emulate the switchdev prepare + commit phase.
>  	 */
> 
Tested-by: Heiner Kallweit <hkallweit1@xxxxxxxxx>

The error has gone. New with the original patch is just the following
message in syslog when bringing the device up. I'm not sure there is
benefit in it (at least for VLAN 0 because it's a no-op).

8021q: adding VLAN 0 to HW filter on device eth_cu_1000_2