RE: [PATCH 0/3] can: flexcan: add imx8qm support

[Joakim Zhang]

Kindly Ping...

Best Regards,
Joakim Zhang

> -----Original Message-----
> From: Joakim Zhang
> Sent: 2019年1月17日 14:28
> To: mkl@xxxxxxxxxxxxxx; linux-can@xxxxxxxxxxxxxxx
> Cc: wg@xxxxxxxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
> linux-kernel@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>
> Subject: RE: [PATCH 0/3] can: flexcan: add imx8qm support
> 
> 
> Kindly Ping...
> 
> Best Regards,
> Joakim Zhang
> 
> > -----Original Message-----
> > From: Joakim Zhang
> > Sent: 2018年12月19日 16:39
> > To: mkl@xxxxxxxxxxxxxx; linux-can@xxxxxxxxxxxxxxx
> > Cc: wg@xxxxxxxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
> > linux-kernel@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>; Joakim
> > Zhang <qiangqing.zhang@xxxxxxx>
> > Subject: [PATCH 0/3] can: flexcan: add imx8qm support
> >
> > This patch set intends to add Flexcan support for i.MX8QM platform
> > which defaultly supports CAN FD protocol. Although BRS enabled by
> > system reset when the driver sets CAN FD mode, now this patch serial
> > does not support BRS in the driver. And then I will send patch to
> > enable BRS by changing the register to set bit timing.
> >
> > Dong Aisheng (3):
> >   can: rx-offload: add CANFD support based on offload
> >   can: flexcan: add CAN FD mode support
> >   can: flexcan: add imx8qm support
> >
> >  drivers/net/can/flexcan.c      | 114
> ++++++++++++++++++++++++++++++---
> >  drivers/net/can/rx-offload.c   |  16 +++--
> >  include/linux/can/rx-offload.h |   4 +-
> >  3 files changed, 117 insertions(+), 17 deletions(-)
> >
> > --
> > 2.17.1