[PATCH] PCI: qcom: Don't deassert reset GPIO during probe

[Bjorn Andersson]

Acquiring the reset GPIO low means that reset is being deasserted, this
is followed almost immediately with qcom_pcie_host_init() asserting it,
initializing it and then finally deasserting it again, for the link to
come up.

Some PCIe devices requires a minimum time between the initial deassert
and subsequent reset cycles. In a platform that boots with the reset
GPIO asserted this requirement is being violated by this deassert/assert
pulse.

Acquiring the reset GPIO high will prevent this by matching the state to
the subsequent asserted state.

Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index d185ea5fe996..a7f703556790 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -1228,7 +1228,7 @@ static int qcom_pcie_probe(struct platform_device *pdev)
 
 	pcie->ops = of_device_get_match_data(dev);
 
-	pcie->reset = devm_gpiod_get_optional(dev, "perst", GPIOD_OUT_LOW);
+	pcie->reset = devm_gpiod_get_optional(dev, "perst", GPIOD_OUT_HIGH);
 	if (IS_ERR(pcie->reset)) {
 		ret = PTR_ERR(pcie->reset);
 		goto err_pm_runtime_put;
-- 
2.18.0