[PATCH v4 1/2] dt-bindings: usb: ci-hdrc-usb2: add property power-active-high

[Philipp Puschmann]

The i.MX USB controller may drive the usb power line directly, but the
polarity depends on the board. Reset state of the polarity is low-active so
add this property to allow it to be high-active.

Signed-off-by: Philipp Puschmann <philipp.puschmann@xxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>

---
Changes in v4: do not limit to i.MX6

 Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 +
 1 file changed, 1 insertion(+)

diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
index adae82385dd6..a254386a91ad 100644
--- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
+++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
@@ -93,6 +93,7 @@ i.mx specific properties
 - over-current-active-low: over current signal polarity is active low.
 - over-current-active-high: over current signal polarity is active high.
   It's recommended to specify the over current polarity.
+- power-active-high: power signal polarity is active high
 - external-vbus-divider: enables off-chip resistor divider for Vbus
 
 Example:
-- 
2.20.1