Re: [PATCH v4 2/2] mtd: spi-nor: cadence-quadspi: Add support for Octal SPI controller

[Vignesh R]

On 23-Jan-19 2:15 PM, Boris Brezillon wrote:
> On Tue, 22 Jan 2019 12:11:37 +0530
> Vignesh R <vigneshr@xxxxxx> wrote:
> 
>> Cadence OSPI controller IP supports Octal IO (x8 IO lines),
>> It also has an integrated PHY. IP register layout is very
>> similar to existing QSPI IP except for additional bits to support Octal
>> and Octal DDR mode. Therefore, extend current driver to support Octal
>> mode. Only Octal SDR read (1-1-8)mode is supported for now.
>>
>> Tested with mt35xu512aba Octal flash on TI's AM654 EVM.
>>
>> Signed-off-by: Vignesh R <vigneshr@xxxxxx>
>> ---
>>
>> v4: Fix comments by Tudor on v3
>> v3: No changes
>> v2: Declare Octal mode capability based on compatible.
>>
>>  drivers/mtd/spi-nor/cadence-quadspi.c | 53 +++++++++++++++++++++------
>>  1 file changed, 41 insertions(+), 12 deletions(-)
>>
>> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
>> index 04cedd3a2bf6..2091addc45a3 100644
>> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
>> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
>> @@ -44,6 +44,12 @@
>>  /* Quirks */
>>  #define CQSPI_NEEDS_WR_DELAY		BIT(0)
>>  
>> +/* Capabilities mask */
>> +#define cqspi_base_hwcaps_mask					\
> 
> Nit: we usually use upper cases for such definitions.
> 

Will fix.

>> +	(SNOR_HWCAPS_READ | SNOR_HWCAPS_READ_FAST |		\
>> +	SNOR_HWCAPS_READ_1_1_2 | SNOR_HWCAPS_READ_1_1_4 |	\
>> +	SNOR_HWCAPS_PP)
>> +
>>  struct cqspi_st;
>>  
>>  struct cqspi_flash_pdata {
>> @@ -93,6 +99,11 @@ struct cqspi_st {
>>  	struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
>>  };
>>  
>> +struct cqspi_driver_platdata {
>> +	u32 hwcaps_mask;
>> +	u8 quirks;
>> +};
>> +
>>  /* Operation timeout value */
>>  #define CQSPI_TIMEOUT_MS			500
>>  #define CQSPI_READ_TIMEOUT_MS			10
>> @@ -101,6 +112,7 @@ struct cqspi_st {
>>  #define CQSPI_INST_TYPE_SINGLE			0
>>  #define CQSPI_INST_TYPE_DUAL			1
>>  #define CQSPI_INST_TYPE_QUAD			2
>> +#define CQSPI_INST_TYPE_OCTAL			3
>>  
>>  #define CQSPI_DUMMY_CLKS_PER_BYTE		8
>>  #define CQSPI_DUMMY_BYTES_MAX			4
>> @@ -911,6 +923,9 @@ static int cqspi_set_protocol(struct spi_nor *nor, const int read)
>>  		case SNOR_PROTO_1_1_4:
>>  			f_pdata->data_width = CQSPI_INST_TYPE_QUAD;
>>  			break;
>> +		case SNOR_PROTO_1_1_8:
>> +			f_pdata->data_width = CQSPI_INST_TYPE_OCTAL;
>> +			break;
>>  		default:
>>  			return -EINVAL;
>>  		}
>> @@ -1213,21 +1228,22 @@ static void cqspi_request_mmap_dma(struct cqspi_st *cqspi)
>>  
>>  static int cqspi_setup_flash(struct cqspi_st *cqspi, struct device_node *np)
>>  {
>> -	const struct spi_nor_hwcaps hwcaps = {
>> -		.mask = SNOR_HWCAPS_READ |
>> -			SNOR_HWCAPS_READ_FAST |
>> -			SNOR_HWCAPS_READ_1_1_2 |
>> -			SNOR_HWCAPS_READ_1_1_4 |
>> -			SNOR_HWCAPS_PP,
>> -	};
>>  	struct platform_device *pdev = cqspi->pdev;
>>  	struct device *dev = &pdev->dev;
>> +	const struct cqspi_driver_platdata *ddata;
>> +	struct spi_nor_hwcaps hwcaps;
>>  	struct cqspi_flash_pdata *f_pdata;
>>  	struct spi_nor *nor;
>>  	struct mtd_info *mtd;
>>  	unsigned int cs;
>>  	int i, ret;
>>  
>> +	ddata = of_device_get_match_data(dev);
>> +	if (!ddata)
>> +		hwcaps.mask = cqspi_base_hwcaps_mask;
>> +	else
>> +		hwcaps.mask = ddata->hwcaps_mask;
>> +
>>  	/* Get flash device data */
>>  	for_each_available_child_of_node(dev->of_node, np) {
>>  		ret = of_property_read_u32(np, "reg", &cs);
>> @@ -1310,7 +1326,7 @@ static int cqspi_probe(struct platform_device *pdev)
>>  	struct cqspi_st *cqspi;
>>  	struct resource *res;
>>  	struct resource *res_ahb;
>> -	unsigned long data;
>> +	const struct cqspi_driver_platdata *ddata;
>>  	int ret;
>>  	int irq;
>>  
>> @@ -1377,8 +1393,8 @@ static int cqspi_probe(struct platform_device *pdev)
>>  	}
>>  
>>  	cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
>> -	data  = (unsigned long)of_device_get_match_data(dev);
>> -	if (data & CQSPI_NEEDS_WR_DELAY)
>> +	ddata  = of_device_get_match_data(dev);
>> +	if (ddata && (ddata->quirks & CQSPI_NEEDS_WR_DELAY))
>>  		cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
>>  						   cqspi->master_ref_clk_hz);
>>  
>> @@ -1460,14 +1476,27 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
>>  #define CQSPI_DEV_PM_OPS	NULL
>>  #endif
>>  
>> +static const struct cqspi_driver_platdata k2g_qspi = {
>> +	.hwcaps_mask = cqspi_base_hwcaps_mask,
>> +	.quirks = CQSPI_NEEDS_WR_DELAY,
>> +};
>> +
>> +static const struct cqspi_driver_platdata am654_ospi = {
>> +	.hwcaps_mask = cqspi_base_hwcaps_mask | SNOR_HWCAPS_READ_1_1_8,
>> +	.quirks = CQSPI_NEEDS_WR_DELAY,
>> +};
>> +
>>  static const struct of_device_id cqspi_dt_ids[] = {
>>  	{
>>  		.compatible = "cdns,qspi-nor",
>> -		.data = (void *)0,
> 
> Can't we have a cqspi_driver_platdata instance for that one too?

I had that in v3, will add it back. Thanks for the review!

> 
>>  	},
>>  	{
>>  		.compatible = "ti,k2g-qspi",
>> -		.data = (void *)CQSPI_NEEDS_WR_DELAY,
>> +		.data = &k2g_qspi,
>> +	},
>> +	{
>> +		.compatible = "ti,am654-ospi",
>> +		.data = &am654_ospi,
>>  	},
>>  	{ /* end of table */ }
>>  };
> 

Regards
Vignesh