Re: Should this_cpu_read() be volatile?

From: Peter Zijlstra
Date: Sat Dec 08 2018 - 05:53:10 EST


On Fri, Dec 07, 2018 at 04:40:52PM -0800, Nadav Amit wrote:

> > I'm actually having difficulty finding the this_cpu_read() in any of the
> > functions you mention, so I cannot make any concrete suggestions other
> > than pointing at the alternative functions available.
>
>
> So I got deeper into the code to understand a couple of differences. In the
> case of select_idle_sibling(), the patch (Peterâs) increase the function
> code size by 123 bytes (over the baseline of 986). The per-cpu variable is
> called through the following call chain:
>
> select_idle_sibling()
> => select_idle_cpu()
> => local_clock()
> => raw_smp_processor_id()
>
> And results in 2 more calls to sched_clock_cpu(), as the compiler assumes
> the processor id changes in between (which obviously wouldnât happen).

That is the thing with raw_smp_processor_id(), it is allowed to be used
in preemptible context, and there it _obviously_ can change between
subsequent invocations.

So again, this change is actually good.

If we want to fix select_idle_cpu(), we should maybe not use
local_clock() there but use sched_clock_cpu() with a stable argument,
this code runs with IRQs disabled and therefore the CPU number is stable
for us here.

> There may be more changes around, which I didnât fully analyze. But
> the very least reading the processor id should not get âvolatileâ.
>
> As for finish_task_switch(), the impact is only few bytes, but still
> unnecessary. It appears that with your patch preempt_count() causes multiple
> reads of __preempt_count in this code:
>
> if (WARN_ONCE(preempt_count() != 2*PREEMPT_DISABLE_OFFSET,
> "corrupted preempt_count: %s/%d/0x%x\n",
> current->comm, current->pid, preempt_count()))
> preempt_count_set(FORK_PREEMPT_COUNT);

My patch proposed here:

https://marc.info/?l=linux-mm&m=154409548410209

would actually fix that one I think, preempt_count() uses
raw_cpu_read_4() which will loose the volatile with that patch.