Re: Infinite looping observed in __offline_pages

From: Aneesh Kumar K.V
Date: Wed Aug 22 2018 - 05:30:31 EST



Hi Michal,

Michal Hocko <mhocko@xxxxxxxxxx> writes:

> On Wed 25-07-18 13:11:15, John Allen wrote:
> [...]
>> Does a failure in do_migrate_range indicate that the range is unmigratable
>> and the loop in __offline_pages should terminate and goto failed_removal? Or
>> should we allow a certain number of retrys before we
>> give up on migrating the range?
>
> Unfortunatelly not. Migration code doesn't tell a difference between
> ephemeral and permanent failures. We are relying on
> start_isolate_page_range to tell us this. So the question is, what kind
> of page is not migratable and for what reason.
>
> Are you able to add some debugging to give us more information. The
> current debugging code in the hotplug/migration sucks...

Haren did most of the debugging, so at minimum we need a patch like this
I guess.

modified mm/page_alloc.c
@@ -7649,6 +7649,10 @@ bool has_unmovable_pages(struct zone *zone, struct page *page, int count,
* handle each tail page individually in migration.
*/
if (PageHuge(page)) {
+
+ if (!IS_ENABLED(CONFIG_ARCH_ENABLE_HUGEPAGE_MIGRATION))
+ goto unmovable;
+
iter = round_up(iter + 1, 1<<compound_order(page)) - 1;
continue;
}


The problem is start_isolate_range, doesn't look at hugetlbpage and
return error if the architecture didn't support HUGEPAGE migration.

Now discussing with Naoya, I was suggsting whether we should add a
similar check in

modified mm/memory_hotplug.c
@@ -1338,7 +1338,8 @@ static unsigned long scan_movable_pages(unsigned long start, unsigned long end)
return pfn;
if (__PageMovable(page))
return pfn;
- if (PageHuge(page)) {
+ if (IS_ENABLED(CONFIG_ARCH_ENABLE_HUGEPAGE_MIGRATION) &&
+ PageHuge(page)) {
if (page_huge_active(page))
return pfn;

One of the thinking there is it possible to get new hugetlb pages
allocated in that range after start_isolate_range ran. But i guess since
we marked all the free pages as MIGRATE_ISOLATE that is not possible?

But then it is good to have scan_movable_pages also check for
HUGEPAGE_MIGRATION?

Complete patch below.

commit 2e9d754ac211f2af3731f15df3cd8cd070b4cc54
Author: Aneesh Kumar K.V <aneesh.kumar@xxxxxxxxxxxxx>
Date: Tue Aug 21 14:17:55 2018 +0530

mm/hugetlb: filter out hugetlb pages if HUGEPAGE migration is not supported.

When scanning for movable pages, filter out Hugetlb pages if hugepage migration
is not supported. Without this we hit infinte loop in __offline pages where we
do
pfn = scan_movable_pages(start_pfn, end_pfn);
if (pfn) { /* We have movable pages */
ret = do_migrate_range(pfn, end_pfn);
goto repeat;
}

We do support hugetlb migration ony if the hugetlb pages are at pmd level. Here
we just check for Kernel config. The gigantic page size check is done in
page_huge_active.

Reported-by: Haren Myneni <haren@xxxxxxxxxxxxxxxxxx>
CC: Naoya Horiguchi <n-horiguchi@xxxxxxxxxxxxx>
Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@xxxxxxxxxxxxx>

diff --git a/mm/memory_hotplug.c b/mm/memory_hotplug.c
index 4eb6e824a80c..f9bdea685cf4 100644
--- a/mm/memory_hotplug.c
+++ b/mm/memory_hotplug.c
@@ -1338,7 +1338,8 @@ static unsigned long scan_movable_pages(unsigned long start, unsigned long end)
return pfn;
if (__PageMovable(page))
return pfn;
- if (PageHuge(page)) {
+ if (IS_ENABLED(CONFIG_ARCH_ENABLE_HUGEPAGE_MIGRATION) &&
+ PageHuge(page)) {
if (page_huge_active(page))
return pfn;
else
diff --git a/mm/page_alloc.c b/mm/page_alloc.c
index 15ea511fb41c..a3f81e18c882 100644
--- a/mm/page_alloc.c
+++ b/mm/page_alloc.c
@@ -7649,6 +7649,10 @@ bool has_unmovable_pages(struct zone *zone, struct page *page, int count,
* handle each tail page individually in migration.
*/
if (PageHuge(page)) {
+
+ if (!IS_ENABLED(CONFIG_ARCH_ENABLE_HUGEPAGE_MIGRATION))
+ goto unmovable;
+
iter = round_up(iter + 1, 1<<compound_order(page)) - 1;
continue;
}