Re: [PATCH/RFT 2/6] i2c: imx: use open drain for recovery GPIO

[Lucas Stach]

Am Freitag, den 13.07.2018, 23:09 +0200 schrieb Wolfram Sang:
> I2C is open drain, so set up the GPIO accordingly.
> 
> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>

I don't think this matters on any of the i.MX platforms, as the GPIO
pin configuration (including open-drain) is only taken from the DT
pinctrl, with the GPIO driver not being able to change any of those. On
 the flipside this results in a near zero probability of regressions.
;)

As this is obviously right even if it doesn't have any effect on
current software:

Reviewed-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>

> ---
> Âdrivers/i2c/busses/i2c-imx.c | 2 +-
> Â1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/i2c/busses/i2c-imx.c b/drivers/i2c/busses/i2c-imx.c
> index 0207e194f84b..3e23ee26c55c 100644
> --- a/drivers/i2c/busses/i2c-imx.c
> +++ b/drivers/i2c/busses/i2c-imx.c
> @@ -1010,7 +1010,7 @@ static int i2c_imx_init_recovery_info(struct imx_i2c_struct *i2c_imx,
> > Â	i2c_imx->pinctrl_pins_gpio = pinctrl_lookup_state(i2c_imx->pinctrl,
> > Â			"gpio");
> > Â	rinfo->sda_gpiod = devm_gpiod_get(&pdev->dev, "sda", GPIOD_IN);
> > -	rinfo->scl_gpiod = devm_gpiod_get(&pdev->dev, "scl", GPIOD_OUT_HIGH);
> > +	rinfo->scl_gpiod = devm_gpiod_get(&pdev->dev, "scl", GPIOD_OUT_HIGH_OPEN_DRAIN);
> Â
> > Â	if (PTR_ERR(rinfo->sda_gpiod) == -EPROBE_DEFER ||
> > Â	ÂÂÂÂPTR_ERR(rinfo->scl_gpiod) == -EPROBE_DEFER) {