Re: [PATCH 2/2] mtd: rawnand: denali: add more clocks

From: Masahiro Yamada
Date: Tue Jun 12 2018 - 06:37:14 EST


Maybe, the commit title should be:

mtd: rawnand: denali: add more clocks and improve setup_data_interface



2018-06-12 19:31 GMT+09:00 Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx>:
> According to the Denali User's Guide, this IP needs three clock inputs:
>
> - clk: controller core clock
>
> - clk_x: bus interface clock
>
> - ecc_clk: clock at which ECC circuitry is run
>
> Currently, denali_dt.c requires a single anonymous clock and its
> frequency. However, the driver needs to get the frequency of "clk_x"
> not "clk". This is confusing because people tend to assume the
> anonymous clock means the core clock.
>
> Instead of the cheesy implementation, the clocks in the real hardware
> should be represented in the driver code and the DT-binding.
>
> I improved the ->setup_data_interface() hook as well.
>
> The denali_setup_data_interface() needs the frequency of clk_x
> and the ratio of clk_x / clk.
>
> The latter is currently hardcoded in the driver, like this:
>
> #define DENALI_CLK_X_MULT 6
>
> The IP datasheet specifies that clk_x / clk should be 4, 5, or 6.
> I just chose 6 because it is the most defensive value, but it is not
> very nice. By getting the clock rate of both "clk" and "clk_x", the
> driver can compute the timing values more precisely.
>
> Adding new clocks would break the existing platforms. For the backward
> compatibility, the driver still accepts the single clock just as before.
> Also, ->clk_rate and ->clk_x_rate are set to hardcoded values if clk_x
> is missing.
>
> It should work for all upstreamed platforms because Intel Moorestown,
> Altera (Intel) SOCFPGA, Socionext UniPhier use the following clock
> frequency:
>
> clk = 50 MHz
> clk_x = ecc_clk = 200 MHz
>
> Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx>
> ---


--
Best Regards
Masahiro Yamada