Re: [PATCH] mfd: arizona: Don't use regmap_read_poll_timeout

[Charles Keepax]

On Mon, Jun 04, 2018 at 11:27:19AM +0100, Charles Keepax wrote:
> On Mon, Jun 04, 2018 at 12:40:37PM +0300, Andy Shevchenko wrote:
> > On Mon, Jun 4, 2018 at 8:44 AM, Lee Jones <lee.jones@xxxxxxxxxx> wrote:
> > > On Fri, 11 May 2018, Charles Keepax wrote:
> > 
> > >> +     while (true) {
> > >> +             ret = regmap_read(arizona->regmap, reg, &val);
> > >>
> > >> +             if ((val & mask) == target)
> > >> +                     return 0;
> > >> +
> > >> +             if (ktime_compare(ktime_get(), timeout) > 0)
> > >> +                     break;
> > >> +
> > >> +             usleep_range(ARIZONA_REG_POLL_DELAY_US / 2,
> > >> +                          ARIZONA_REG_POLL_DELAY_US);
> > >> +     }
> > 
> > >From my point of view infinite loops not good for readability and maintenance.
> > Perhaps
> > 
> > do {
> > ...
> > } while (ktime_compare(...));
> > 
> > ?
> 
> I would rather not do it that way since then it becomes
> impossible to have a single poll with no delays happening. I can
> refactor to remove the while(true) but it will make the code a
> bit bigger, as I will probably need to duplicate some code
> outside the loop.
> 

Looking again I think it is fine if I do the ktime_compare at the top
of the loop though. Will respin.

Thanks,
Charles