[PATCH] Revert "dmaengine: pl330: add DMA_PAUSE feature"

[Frank Mori Hess]

This reverts commit 88987d2c7534a0269f567fb101e6d71a08f0f01d.

The pl330.c pause implementation violates the dmaengine requirement
for no data loss, since it relies on the DMAKILL
instruction.  However, DMAKILL discards in-flight data from the
dma controller's fifo.  This is documented in the dma-330 manual
and I have observed it with hardware doing device-to-memory burst
transfers.  The discarded data may or may not show up in the
residue count, depending on timing (resulting in data corruption
effectively).

Signed-off-by: Frank Mori Hess <fmh6jj@xxxxxxxxx>
---
 drivers/dma/pl330.c | 28 ----------------------------
 1 file changed, 28 deletions(-)

diff --git a/drivers/dma/pl330.c b/drivers/dma/pl330.c
index 6237069001c4..f802bd3b0481 100644
--- a/drivers/dma/pl330.c
+++ b/drivers/dma/pl330.c
@@ -2290,33 +2290,6 @@ static int pl330_terminate_all(struct dma_chan *chan)
 	return 0;
 }
 
-/*
- * We don't support DMA_RESUME command because of hardware
- * limitations, so after pausing the channel we cannot restore
- * it to active state. We have to terminate channel and setup
- * DMA transfer again. This pause feature was implemented to
- * allow safely read residue before channel termination.
- */
-static int pl330_pause(struct dma_chan *chan)
-{
-	struct dma_pl330_chan *pch = to_pchan(chan);
-	struct pl330_dmac *pl330 = pch->dmac;
-	unsigned long flags;
-
-	pm_runtime_get_sync(pl330->ddma.dev);
-	spin_lock_irqsave(&pch->lock, flags);
-
-	spin_lock(&pl330->lock);
-	_stop(pch->thread);
-	spin_unlock(&pl330->lock);
-
-	spin_unlock_irqrestore(&pch->lock, flags);
-	pm_runtime_mark_last_busy(pl330->ddma.dev);
-	pm_runtime_put_autosuspend(pl330->ddma.dev);
-
-	return 0;
-}
-
 static void pl330_free_chan_resources(struct dma_chan *chan)
 {
 	struct dma_pl330_chan *pch = to_pchan(chan);
@@ -3027,7 +3000,6 @@ pl330_probe(struct amba_device *adev, const struct amba_id *id)
 	pd->device_tx_status = pl330_tx_status;
 	pd->device_prep_slave_sg = pl330_prep_slave_sg;
 	pd->device_config = pl330_config;
-	pd->device_pause = pl330_pause;
 	pd->device_terminate_all = pl330_terminate_all;
 	pd->device_issue_pending = pl330_issue_pending;
 	pd->src_addr_widths = PL330_DMA_BUSWIDTHS;
-- 
2.11.0