[PATCH v2 3/5] dt-bindings: at24: fix formatting and style

From: Bartosz Golaszewski
Date: Thu Dec 21 2017 - 08:49:48 EST


Make formatting and style consistent for the entire document.

This patch doesn't change the content of the binding.

Signed-off-by: Bartosz Golaszewski <brgl@xxxxxxxx>
Reviewed-by: Javier Martinez Canillas <javierm@xxxxxxxxxx>
---
Documentation/devicetree/bindings/eeprom/at24.txt | 24 +++++++++++------------
1 file changed, 12 insertions(+), 12 deletions(-)

diff --git a/Documentation/devicetree/bindings/eeprom/at24.txt b/Documentation/devicetree/bindings/eeprom/at24.txt
index 2702f2456971..1068b4309fed 100644
--- a/Documentation/devicetree/bindings/eeprom/at24.txt
+++ b/Documentation/devicetree/bindings/eeprom/at24.txt
@@ -2,7 +2,7 @@ EEPROMs (I2C)

Required properties:

- - compatible: must be one of the following:
+ - compatible: Must be one of the following:

"atmel,24c00",
"atmel,24c01",
@@ -30,23 +30,23 @@ Required properties:

will still work, but are now deprecated.

- - reg : the I2C address of the EEPROM
+ - reg: The I2C address of the EEPROM.

Optional properties:

- - pagesize : the length of the pagesize for writing. Please consult the
- manual of your device, that value varies a lot. A wrong value
- may result in data loss! If not specified, a safety value of
- '1' is used which will be very slow.
+ - pagesize: The length of the pagesize for writing. Please consult the
+ manual of your device, that value varies a lot. A wrong value
+ may result in data loss! If not specified, a safety value of
+ '1' is used which will be very slow.

- - read-only: this parameterless property disables writes to the eeprom
+ - read-only: This parameterless property disables writes to the eeprom.

- - size: total eeprom size in bytes
+ - size: Total eeprom size in bytes.

- - no-read-rollover:
- This parameterless property indicates that the multi-address
- eeprom does not automatically roll over reads to the next
- slave address. Please consult the manual of your device.
+ - no-read-rollover: This parameterless property indicates that the
+ multi-address eeprom does not automatically roll over
+ reads to the next slave address. Please consult the
+ manual of your device.

- wp-gpios: GPIO to which the write-protect pin of the chip is connected.

--
2.15.1