Re: [PATCH] iio: accel: bmc150: Add OF device ID table

From: Javier Martinez Canillas
Date: Sat Dec 02 2017 - 20:12:09 EST


Hello Jonathan,

On 12/02/2017 01:02 PM, Jonathan Cameron wrote:
> On Fri, 1 Dec 2017 12:10:58 +0100
> Javier Martinez Canillas <javierm@xxxxxxxxxx> wrote:
>
>> The driver doesn't have a struct of_device_id table but supported devices
>> are registered via Device Trees. This is working on the assumption that a
>> I2C device registered via OF will always match a legacy I2C device ID and
>> that the MODALIAS reported will always be of the form i2c:<device>.
>>
>> But this could change in the future so the correct approach is to have an
>> OF device ID table if the devices are registered via OF.
>>
>> The I2C device ID table entries have the .driver_data field set, but they
>> are not used in the driver so weren't set in the OF device table entries.
>>
>> Signed-off-by: Javier Martinez Canillas <javierm@xxxxxxxxxx>
>
> Applied to the togreg branch of iio.git and pushed out as testing
> for the autobuilders to play with it.
>
> Would be nice to do the spi counterpart at somepoint, but as this is
> clearly an improvement on nothing I applied this one as step 1.
>

Ok, I can do the same for SPI. I'll post a patch for it next week.

> Good point about the data fields though - we should probably clean those
> out as misleading.
>

Same for this, I can post a cleanup patch to get rid of the .data fields.

> Thanks,
>
> Jonathan

Best regards,
--
Javier Martinez Canillas
Software Engineer - Desktop Hardware Enablement
Red Hat