[PATCH v2 2/2] mtd: nand: denali: fix setup_data_interface to meet tCCS delay

From: Masahiro Yamada
Date: Fri Sep 29 2017 - 06:41:27 EST


The WE_2_RE register specifies the number of clock cycles inserted
between the rising edge of #WE and the falling edge of #RE.

The current setup_data_interface implementation takes care of tWHR,
but tCCS is missing. Wait max(tCSS, tWHR) to meet the spec.

With setup_data_interface() is properly programmed, the Denali NAND
controller can observe the timing, so NAND_WAIT_{TCCS,TWHR} flag is
unneeded. Say this in the comment block.

Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx>
---

Changes in v2:
- newly added

drivers/mtd/nand/denali.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index 0b268ec..332c022 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -1004,8 +1004,14 @@ static int denali_setup_data_interface(struct mtd_info *mtd, int chipnr,
tmp |= FIELD_PREP(RE_2_RE__VALUE, re_2_re);
iowrite32(tmp, denali->reg + RE_2_RE);

- /* tWHR -> WE_2_RE */
- we_2_re = DIV_ROUND_UP(timings->tWHR_min, t_clk);
+ /*
+ * tCCS, tWHR -> WE_2_RE
+ *
+ * With WE_2_RE properly set, the Denali controller automatically takes
+ * care of tCCS, tWHR; the driver need not set NAND_WAIT_{TCCS,TWHR}.
+ */
+ we_2_re = DIV_ROUND_UP(max(timings->tCCS_min, timings->tWHR_min),
+ t_clk);
we_2_re = min_t(int, we_2_re, TWHR2_AND_WE_2_RE__WE_2_RE);

tmp = ioread32(denali->reg + TWHR2_AND_WE_2_RE);
--
2.7.4