Re: [PATCH v4 3/3] ARM: dts: exynos: Remove the display-timing and delay from rinato dts

[Krzysztof Kozlowski]

On Tue, Aug 29, 2017 at 4:52 AM, Hoegeun Kwon <hoegeun.kwon@xxxxxxxxxxx> wrote:
> Hi Krzysztof,
>
> The driver has been merged into exynos-drm-misc.
> Could you please check this patch(3/3).

Hi, OK, no problems for me but it is too late for current cycle so it
will go in for v4.15.

Best regards,
Krzysztof

>
> Best regards,
> Hoegeun
>
>
> On 07/13/2017 11:20 AM, Hoegeun Kwon wrote:
>>
>> The display-timing and delay are included in the panel driver. So it
>> should be removed in dts.
>>
>> Signed-off-by: Hoegeun Kwon <hoegeun.kwon@xxxxxxxxxxx>
>> ---
>>   arch/arm/boot/dts/exynos3250-rinato.dts | 22 ----------------------
>>   1 file changed, 22 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/exynos3250-rinato.dts
>> b/arch/arm/boot/dts/exynos3250-rinato.dts
>> index 443e0c9..6b70c8d 100644
>> --- a/arch/arm/boot/dts/exynos3250-rinato.dts
>> +++ b/arch/arm/boot/dts/exynos3250-rinato.dts
>> @@ -242,28 +242,6 @@
>>                 vci-supply = <&ldo20_reg>;
>>                 reset-gpios = <&gpe0 1 GPIO_ACTIVE_LOW>;
>>                 te-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
>> -               power-on-delay= <30>;
>> -               power-off-delay= <120>;
>> -               reset-delay = <5>;
>> -               init-delay = <100>;
>> -               flip-horizontal;
>> -               flip-vertical;
>> -               panel-width-mm = <29>;
>> -               panel-height-mm = <29>;
>> -
>> -               display-timings {
>> -                       timing-0 {
>> -                               clock-frequency = <4600000>;
>> -                               hactive = <320>;
>> -                               vactive = <320>;
>> -                               hfront-porch = <1>;
>> -                               hback-porch = <1>;
>> -                               hsync-len = <1>;
>> -                               vfront-porch = <150>;
>> -                               vback-porch = <1>;
>> -                               vsync-len = <2>;
>> -                       };
>> -               };
>>                 port {
>>                         dsi_in: endpoint {
>
>