Re: [PATCH 1/2] spi: rockchip: add support for "cs-gpios" dts property

From: Geert Uytterhoeven
Date: Mon Jun 12 2017 - 04:18:14 EST


On Mon, Jun 12, 2017 at 9:15 AM, Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> wrote:
> On 2017/6/12 14:14, Jeffy Chen wrote:
>>
>> Support using "cs-gpios" property to specify cs gpios.
>>
>> Signed-off-by: Jeffy Chen <jeffy.chen@xxxxxxxxxxxxxx>

>> index 83da493..02171b2 100644
>> --- a/Documentation/devicetree/bindings/spi/spi-rockchip.txt
>> +++ b/Documentation/devicetree/bindings/spi/spi-rockchip.txt
>> @@ -17,6 +17,7 @@ Required Properties:
>> region.
>> - interrupts: The interrupt number to the cpu. The interrupt specifier
>> format
>> depends on the interrupt controller.
>> +- cs-gpios : Specifies the gpio pins to be used for chipselects.
>
> It's not a required property, otherwise how other boards work as your
> patch 2 only add this for rk3399-gru.

>> --- a/drivers/spi/spi-rockchip.c
>> +++ b/drivers/spi/spi-rockchip.c

>> @@ -297,6 +302,50 @@ static void rockchip_spi_set_cs(struct spi_device
>> *spi, bool enable)
>> pm_runtime_put_sync(rs->dev);
>> }
>> +static int rockchip_spi_setup(struct spi_device *spi)
>> +{
>> + int ret = 0;
>> + unsigned long flags = (spi->mode & SPI_CS_HIGH) ?
>> + GPIOF_OUT_INIT_LOW : GPIOF_OUT_INIT_HIGH;
>> + struct rockchip_spi_data *data = spi_get_ctldata(spi);
>> +
>> + if (!gpio_is_valid(spi->cs_gpio))
>> + return 0;

> return -EINVAL?

Isn't this check meant to fall back to hardware CS if no cs-gpios property
is present?

Gr{oetje,eeting}s,

Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds