Re: [PATCH v5 1/4] usb: dbc: early driver for xhci debug capability

[Ingo Molnar]

* Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx> wrote:

> Hi Ingo,
> 
> On 01/22/2017 05:04 PM, Ingo Molnar wrote:
> > * Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx> wrote:
> >
> >>>> +static void xdbc_runtime_delay(unsigned long count)
> >>>> +{
> >>>> +	udelay(count);
> >>>> +}
> >>>> +static void (*xdbc_delay)(unsigned long) = xdbc_early_delay;
> >>> Is this udelay() complication really necessary? udelay() should work fine even in 
> >>> early code. It might not be precisely calibrated, but should be good enough.
> >> I tried udelay() in the early code. It's not precise enough for the
> >> hardware handshaking.
> > Possibly because on x86 early udelay() did not work at all - i.e. there's no delay 
> > whatsoever.
> 
> Yes.
> 
> >
> > Could you try it on top of this commit in tip:timers/core:
> >
> >   4c45c5167c95 x86/timer: Make delay() work during early bootup
> >
> > ?
> 
> I tried tip:timers/core. It's not precise enough for my context either.
> 
> __const_udelay().
> 
> 157 inline void __const_udelay(unsigned long xloops)
> 158 {
> 159         unsigned long lpj = this_cpu_read(cpu_info.loops_per_jiffy) ? : loops_per_jiffy;
> 160         int d0;
> 161
> 162         xloops *= 4;
> 163         asm("mull %%edx"
> 164                 :"=d" (xloops), "=&a" (d0)
> 165                 :"1" (xloops), "0" (lpj * (HZ / 4)));
> 166
> 167         __delay(++xloops);
> 168 }
> 
> 
> In my early  code, loops_per_jiffy is not initialized yet. Hence "lpj" for the asm line
> is 4096 (default value).
> 
> The  cpu_info.loops_per_jiffy actually reads 8832000 after initialization. They are
> about 2000 times different.
> 
> I did a hacky test in kernel to check the difference between these two different
> "lpj" values. (The hacky patch is attached.) Below is the output for 100ms delay.
> 
> [    2.494751] udelay_test uninitialized ---->start
> [    2.494820] udelay_test uninitialized ---->end
> [    2.494828] udelay_test initialized ---->start
> [    2.595234] udelay_test initialized ---->end
> 
> For 100ms delay, udelay() with uninitialized loops_per_jiffy only gives a delay of
> only 69us.

Ok, then could we add some simple calibration to make udelay work much better - or 
perhaps move the udelay calibration up earlier?

Hiding essentially an early udelay() implementation in an early-printk driver is 
ugly and counterproductive.

Thanks,

	Ingo