Re: [PATCH v10 2/3] Documentation: Add binding document for Lattice iCE40 FPGA manager

From: Geert Uytterhoeven
Date: Mon Dec 19 2016 - 06:16:56 EST


Hi Joel,

On Sun, Dec 18, 2016 at 6:33 AM, Joel Holdsworth
<joel@xxxxxxxxxxxxxxxxxxx> wrote:
> This adds documentation of the device tree bindings of the Lattice iCE40
> FPGA driver for the FPGA manager framework.
>
> Signed-off-by: Joel Holdsworth <joel@xxxxxxxxxxxxxxxxxxx>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
> Acked-by: Alan Tull <atull@xxxxxxxxxxxxxxxxxxxxx>
> Acked-by: Moritz Fischer <moritz.fischer@xxxxxxxxx>
> Acked-by: Marek Vasut <marex@xxxxxxx>

> --- /dev/null
> +++ b/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt
> @@ -0,0 +1,21 @@
> +Lattice iCE40 FPGA Manager
> +
> +Required properties:
> +- compatible: Should contain "lattice,ice40-fpga-mgr"
> +- reg: SPI chip select
> +- spi-max-frequency: Maximum SPI frequency (>=1000000, <=25000000)
> +- cdone-gpios: GPIO input connected to CDONE pin
> +- reset-gpios: Active-low GPIO output connected to CRESET_B pin. Note
> + that unless the GPIO is held low during startup, the
> + FPGA will enter Master SPI mode and drive SCK with a
> + clock signal potentially jamming other devices on the
> + bus until the firmware is loaded.
> +
> +Example:
> + ice40: ice40@0 {

As per ePAPR, node names should be generic names, e.g. "fpga@0".
Sorry for not noticing before.

> + compatible = "lattice,ice40-fpga-mgr";
> + reg = <0>;
> + spi-max-frequency = <1000000>;
> + cdone-gpios = <&gpio 24 GPIO_ACTIVE_HIGH>;
> + reset-gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
> + };

Gr{oetje,eeting}s,

Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds