Re: Tearing down DMA transfer setup after DMA client has finished

From: Mason
Date: Thu Dec 08 2016 - 05:55:43 EST


On 08/12/2016 11:39, Vinod Koul wrote:

> On Wed, Dec 07, 2016 at 04:45:58PM +0000, Måns Rullgård wrote:
>
>> Vinod Koul <vinod.koul@xxxxxxxxx> writes:
>>
>>> On Tue, Dec 06, 2016 at 01:14:20PM +0000, Måns Rullgård wrote:
>>>>
>>>> That's not going to work very well. Device drivers typically request
>>>> dma channels in their probe functions or when the device is opened.
>>>> This means that reserving one of the few channels there will inevitably
>>>> make some other device fail to operate.
>>>
>>> No that doesn't make sense at all, you should get a channel only when you
>>> want to use it and not in probe!
>>
>> Tell that to just about every single driver ever written.
>
> Not really, few do yes which is wrong but not _all_ do that.

Vinod,

Could you explain something to me in layman's terms?

I have a NAND Flash Controller driver that depends on the
DMA driver under discussion.

Suppose I move the dma_request_chan() call from the driver's
probe function, to the actual DMA transfer function.

I would want dma_request_chan() to put the calling thread
to sleep until a channel becomes available (possibly with
a timeout value).

But Maxime told me dma_request_chan() will just return
-EBUSY if no channels are available.

Am I supposed to busy wait in my driver's DMA function
until a channel becomes available?

I don't understand how the multiplexing of few memory
channels to many clients is supposed to happen efficiently?

Regards.