Re: [PATCH v3 1/6] net: stmmac: return error if no DMA configuration is found

From: Alexandre Torgue
Date: Thu Dec 08 2016 - 05:44:45 EST


Hi Niklas,

On 12/07/2016 03:20 PM, Niklas Cassel wrote:
From: Niklas Cassel <niklas.cassel@xxxxxxxx>

All drivers except pci glue layer calls stmmac_probe_config_dt.
stmmac_probe_config_dt does a kzalloc dma_cfg.

pci glue layer does kzalloc dma_cfg explicitly, so all current
drivers does a kzalloc dma_cfg.

Return an error if no DMA configuration is found, that way
we can assume that the DMA configuration always exists.

Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxxx>

Acked-by: Alexandre Torgue <alexandre.torgue@stcom>

---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 982c95213da4..14366800e5e6 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1578,16 +1578,12 @@ static void stmmac_check_ether_addr(struct stmmac_priv *priv)
*/
static int stmmac_init_dma_engine(struct stmmac_priv *priv)
{
- int pbl = DEFAULT_DMA_PBL, fixed_burst = 0, aal = 0;
- int mixed_burst = 0;
int atds = 0;
int ret = 0;

- if (priv->plat->dma_cfg) {
- pbl = priv->plat->dma_cfg->pbl;
- fixed_burst = priv->plat->dma_cfg->fixed_burst;
- mixed_burst = priv->plat->dma_cfg->mixed_burst;
- aal = priv->plat->dma_cfg->aal;
+ if (!priv->plat->dma_cfg) {
+ dev_err(priv->device, "DMA configuration not found\n");
+ return -EINVAL;
}

if (priv->extend_desc && (priv->mode == STMMAC_RING_MODE))
@@ -1599,8 +1595,12 @@ static int stmmac_init_dma_engine(struct stmmac_priv *priv)
return ret;
}

- priv->hw->dma->init(priv->ioaddr, pbl, fixed_burst, mixed_burst,
- aal, priv->dma_tx_phy, priv->dma_rx_phy, atds);
+ priv->hw->dma->init(priv->ioaddr,
+ priv->plat->dma_cfg->pbl,
+ priv->plat->dma_cfg->fixed_burst,
+ priv->plat->dma_cfg->mixed_burst,
+ priv->plat->dma_cfg->aal,
+ priv->dma_tx_phy, priv->dma_rx_phy, atds);

if (priv->synopsys_id >= DWMAC_CORE_4_00) {
priv->rx_tail_addr = priv->dma_rx_phy +