Re: [PATCH v2 3/4] Device bindings documentation updated ACPI-enabled platforms not currently supported

From: Luis Oliveira
Date: Tue Nov 08 2016 - 09:19:46 EST


Hi,


As you suggested I will split the drivers. I am thinking of doing 5 patches:

- factor out master() parts

- separate Master part to i2c-designware-master.c (changes in i2c-designware-core.c)

- enable Slave part to i2c-designware-slave (changes in i2c-designware-core.c)

- glue drivers and device bindings

- cleaning


Regards,

Luis

On 21-Oct-16 11:54, Andy Shevchenko wrote:
> On Fri, 2016-10-21 at 10:56 +0100, Luis Oliveira wrote:
>> Since practically 90% of the code is shared between master and slave,
>> I was
>> thinking if it will be acceptable to use the same driver for both but
>> differentiate the master/slave mode by the compatible strings.
> It might be possible to split like other drivers do:
>
> 1. Core part (i2c-designware-core.c)
> 2. Master part (i2c-designware-master.c)
> 3. Slave part (i2c-designware-slave.c)
> 4. Glue drivers (like: i2c-designware-platdrv.c)
>
>> Thanks,
>> Luis
>>
>> On 10/18/2016 16:17, Wolfram Sang wrote:
>>>> This is needed because the configuration is different and the i2c-
>>>> designware
>>>> cannot be master/slave without a reset. To resolve that I added
>>>> this property
>>>> to bind it as a slave when needed.
>>> Aww, pity that the HW can't do that. Do you have details why?
>>>
>>> If that is really a HW limitation, then I'd suggest having a
>>> seperate
>>> driver for slave-only mode so we can differentiate by compatible
>>> strings.
>>>
>>