Re: [PATCH V5] pinctrl: qcom: Add msm8994 pinctrl driver

[Linus Walleij]

On Thu, Nov 3, 2016 at 10:15 PM, Michael Scott <michael.scott@xxxxxxxxxx> wrote:

> Initial pinctrl driver for QCOM msm8994 platforms.
>
> In order to continue the initial board support for QCOM msm8994/msm8992
> presented in patches from Jeremy McNicoll <jeremymc@xxxxxxxxxx>, let's put
> a proper pinctrl driver in place.
>
> Currently, the DT for these platforms uses the msm8x74 pinctrl driver to
> enable basic UART.  Beyond the first few pins the rest are different enough
> to justify it's own driver.
>
> Note: This driver is also used by QCOM's msm8992 platform as it's TLM block
> is the same.
>
> - Initial formatting and style was taken from the msm8x74 pinctrl driver
>   added by BjÃrn Andersson <bjorn.andersson@xxxxxxxxxx>
> - Data was then adjusted per QCOM MSM8994v2 documentation for Top Level
>   Multiplexing
> - Bindings documentation was based on qcom,msm8996-pinctrl.txt by
>   Joonwoo Park <joonwoop@xxxxxxxxxxxxxx> and then modified for msm8994
>   content
>
> Signed-off-by: Michael Scott <michael.scott@xxxxxxxxxx>
> Tested-by: Jeremy McNicoll <jeremymc@xxxxxxxxxx>
> Acked-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
> ---
> V5:

This v5 version applied.

Yours,
Linus Walleij