[PATCH 0/7] pinctrl: soc/tegra: Add support to configure IO rail voltage and pad power states

From: Laxman Dewangan
Date: Tue Apr 12 2016 - 11:15:33 EST


NVIDIA Tegra210 supports the IO pads which can operate at 1.8V
or 3.3V I/O voltage levels. Also the IO pads can be configured
for power down state if it is not used. SW needs to configure the
voltage level of IO pads based on IO rail voltage and its power
state based on platform usage.

The voltage rail configuration and pad power states are done in
Tegra PMC registers.

This series add the required interface in soc/tegra/pmc for required
configruations. This series also add the pincontrol driver for tegra210
IO pads conifguration. This will helps to provide framework for IO pad
configurations via pincontrol DT support and pincontrol dynamic
configruations.

Laxman Dewangan (7):
soc/tegra: pmc: Use BIT macro for register field definition
soc/tegra: pmc: Add new Tegra210 IO rails
soc/tegra: pmc: Add interface to get IO rail power status
soc/tegra: pmc: Add interface to set voltage of IO rails
soc/tegra: pmc: Register sub-devices of PMC
pinctrl: tegra: Add DT binding for io pads control
pinctrl: tegra: Add driver to configure voltage and power state of io
pads

.../bindings/pinctrl/nvidia,tegra210-io-pad.txt | 102 +++++++
drivers/pinctrl/tegra/Kconfig | 11 +
drivers/pinctrl/tegra/Makefile | 1 +
drivers/pinctrl/tegra/pinctrl-tegra210-io-pad.c | 302 +++++++++++++++++++++
drivers/soc/tegra/pmc.c | 159 +++++++++--
.../dt-bindings/pinctrl/pinctrl-tegra210-io-pad.h | 24 ++
include/soc/tegra/pmc.h | 52 ++++
7 files changed, 630 insertions(+), 21 deletions(-)
create mode 100644 Documentation/devicetree/bindings/pinctrl/nvidia,tegra210-io-pad.txt
create mode 100644 drivers/pinctrl/tegra/pinctrl-tegra210-io-pad.c
create mode 100644 include/dt-bindings/pinctrl/pinctrl-tegra210-io-pad.h

--
2.1.4