Re: [PATCH v2 5/5] ASoC: adau17x1: Support platform data via DT

[Rob Herring]

On Tue, Feb 16, 2016 at 01:56:45PM +0100, Andreas Irestål wrote:
> Currently, it is only possible to configure HW-specific options to the
> adau17x1 codecs by providing a platform data struct. With this patch,
> it is possible to provide the same data via DT instead.

The subject is a red flag. Platform data and DT properties are not 
necessarily equivalent.

This should be part of the previous patch.

> 
> Signed-off-by: Andreas Irestål <andire@xxxxxxxx>
> ---
>  .../devicetree/bindings/sound/adi,adau17x1.txt     |  31 +++++
>  include/dt-bindings/sound/adau17x1.h               |  14 +++
>  sound/soc/codecs/adau1761.c                        | 127 +++++++++++++++++++++
>  sound/soc/codecs/adau1781.c                        |  48 ++++++++
>  4 files changed, 220 insertions(+)
>  create mode 100644 include/dt-bindings/sound/adau17x1.h
> 
> diff --git a/Documentation/devicetree/bindings/sound/adi,adau17x1.txt b/Documentation/devicetree/bindings/sound/adi,adau17x1.txt
> index 8dbce0e..6050602 100644
> --- a/Documentation/devicetree/bindings/sound/adi,adau17x1.txt
> +++ b/Documentation/devicetree/bindings/sound/adi,adau17x1.txt
> @@ -13,6 +13,32 @@ Required properties:
>   - reg:			The i2c address. Value depends on the state of ADDR0
>  			and ADDR1, as wired in hardware.
>  
> +Optional properties:
> +
> + - adi,input-differential	bool to set if the input is differential
> + - adi,digital-microphone	bool to set if there is a digital microphone
> +				connected to digmic/jackdet pin.
> + - adi,micbias-vg		Microphone bias voltage

In what units? Add units suffix. Also, this seems like something that 
should be common.

> +	MICBIAS_0_90_AVDD - 0.9 * AVDD
> +	MICBIAS_0_65_AVDD - 0.65 * AVDD

What does this mean?

> +
> +Optional properties (ADAU1361/ADAU1461/ADAU1761/ADAU1961 only)
> +
> + - adi,jack-detection	If present, configures codec to use the digmic/jackdet
> +			pin for jack detection. must provide one of
> +			JACKDETECT_ACTIVE_LO or JACKDETECT_ACTIVE_HI followed
> +			by debounce time in ms, which must be 5, 10, 20, or 40.

Seems like this could be common. No existing examples to copy?

> +
> + - adi,lineout-mode	Set output mode of the lineout pins.
> + - adi,headphone-mode	Set output mode of the headphone pins.
> +
> +The output mode must be one of:
> +	OUTPUT_MODE_HEADPHONE           - Headphone output
> +	OUTPUT_MODE_HEADPHONE_CAPLESS   - Capless headphone output
> +	OUTPUT_MODE_LINE                - Line output