Re: [PATCH 1/2] pinctrl: mediatek: fix direction control issue

From: Linus Walleij
Date: Tue Feb 16 2016 - 07:28:57 EST


On Tue, Feb 16, 2016 at 9:54 AM, Yingjoe Chen <yingjoe.chen@xxxxxxxxxxxx> wrote:

> To make it more clear, for a GPIO pin to get input on MTK chip, we must:
>
> - Enable input for the pad (input-enable)

This should be done by the pin control portions of the driver in
response to the PIN_CONFIG_INPUT_ENABLE generic pin
config setting.

Possibly *also* by just writing the hardware registers
from the callbacks right below here:

> - Set mux to GPIO mode

This should be done by just writing the hardware registers
in these callbacks from struct pinmux_ops:

int (*gpio_request_enable) (struct pinctrl_dev *pctldev,
struct pinctrl_gpio_range *range,
unsigned offset);
void (*gpio_disable_free) (struct pinctrl_dev *pctldev,
struct pinctrl_gpio_range *range,
unsigned offset);
int (*gpio_set_direction) (struct pinctrl_dev *pctldev,
struct pinctrl_gpio_range *range,
unsigned offset,
bool input);

In respons to these functions being called from the corresponding
GPIO driver:

extern int pinctrl_request_gpio(unsigned gpio);
extern void pinctrl_free_gpio(unsigned gpio);
extern int pinctrl_gpio_direction_input(unsigned gpio);
extern int pinctrl_gpio_direction_output(unsigned gpio);

> - Set GPIO direction to input

This should be done in these callbacks from struct gpio_chip:

int (*direction_input)(struct gpio_chip *chip,
unsigned offset);
int (*direction_output)(struct gpio_chip *chip,
unsigned offset, int value);

By just writing the hardware registers.

> Currently user need to add a dts node to set pinmux to GPIO mode with
> input-enable property, the driver need to call gpio_direction_input to
> set direction.

It seems like:

- Your GPIO driver is not calling the pinctrl_request_gpio/
pinctrl_gpio_direction_* etc.

- Your pinmux driver is not implementing the GPIO-specifif
.gpio_* functions

> Since input-enable and GPIO direction are 2 different things, we now
> think this patch is inappropriate. Instead, user should not required to
> add pinmux node in dts if all he want is use it as plain GPIO input.

If you sort out the above callbacks (also read
Documentation/pinctrl.txt about GPIO) I think it is
clear what you need to do.

Usually you should only need a special pinmux/pinconf node
for a GPIO line if you need to specify pull-up or similar electronic
things for that GPIO.

Yours,
Linus Walleij