[PATCH v4 0/5] pinctrl: sunxi: Add H3 R_PIO controller support

From: Krzysztof Adamski
Date: Tue Feb 09 2016 - 09:59:46 EST


This patch series is extension of my original single patch with the same
subject. It adds support for R_PIO so that GPIO port L can be used in H3
based devices. It was tested on OrangePi PC where PL is connected amount
others to an onboard led, a switch, an IR receiver and some VCC
controllers.

Patchset is based on next-20160209.

---

Changes since v3:
- collect some acked-bys
- fix r_pios #interrupt-cells

Changes since v2:
- fixed apb0 parrent clocks list
- moved binding documentation change to the proper patch
- simplified sunxi_pinctrl_gpio_get according to ChenYu suggestions
- fixed ordering in sunxi binding documentation

Changes since v1:
- splited patch to two separate - dtsi and c files
- added APB0 clocks a parent for R_PIO
- added fix in sunxi_pinctrl_gpio_get for getting pin value when in irq
mode and on 2nd pinctrl
- fixed a "pwn" > "pwm" typo
- fixed order in allwinner,sunxi-pinctrl.txt


Krzysztof Adamski (5):
clk: sunxi: Add apb0 gates for H3
dts: sun8i-h3: Add APB0 related clocks and resets
pinctrl: sunxi: Add H3 R_PIO controller support
ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi
pinctrl: sunxi: Use pin number when calling sunxi_pmx_set

Documentation/devicetree/bindings/clock/sunxi.txt | 1 +
.../bindings/pinctrl/allwinner,sunxi-pinctrl.txt | 1 +
arch/arm/boot/dts/sun8i-h3.dtsi | 36 +++++++
drivers/clk/sunxi/clk-simple-gates.c | 2 +
drivers/pinctrl/sunxi/Kconfig | 4 +
drivers/pinctrl/sunxi/Makefile | 1 +
drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c | 106 +++++++++++++++++++++
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 5 +-
8 files changed, 154 insertions(+), 2 deletions(-)
create mode 100644 drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c

--
2.1.4