[PATCH 1/2] dt-bindings: GPIO: Add generic serializer binding

From: Andrew F. Davis
Date: Fri Dec 11 2015 - 14:47:10 EST


Add binding for generic parallel-in/serial-out shift register devices
used as GPIO.

Signed-off-by: Andrew F. Davis <afd@xxxxxx>
---
.../devicetree/bindings/gpio/gpio-pisosr.txt | 34 ++++++++++++++++++++++
1 file changed, 34 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/gpio-pisosr.txt

diff --git a/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt b/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt
new file mode 100644
index 0000000..e69e8ec
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt
@@ -0,0 +1,34 @@
+Generic Parallel-in/Serial-out Shift Register GPIO Driver
+
+This binding describes generic parallel-in/serial-out shift register
+devices that can be used for GPI (General Purpose Input). This includes
+SN74165 serial-out shift registers and the SN65HVS88x series of
+industrial serializers.
+
+Required properties:
+ - compatible : Should be "pisosr-gpio".
+ - gpio-controller : Marks the device node as a GPIO controller.
+ - #gpio-cells : Should be two. For consumer use see gpio.txt.
+
+Optional properties:
+ - ngpios : Number of GPIO lines, default is 8.
+ - load-gpios : GPIO pin specifier attached to load enable, this
+ pin is pulsed before reading from the device to
+ load input pin values into the the device.
+
+For other required and optional properties of SPI slave
+nodes please refer to ../spi/spi-bus.txt.
+
+Example:
+
+ sn65hvs882@0 {
+ compatible = "pisosr-gpio";
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ load-gpios = <&gpio2 23 GPIO_ACTIVE_LOW>;
+
+ reg = <0>;
+ spi-max-frequency = <1000000>;
+ spi-cpol;
+ };
--
2.6.4

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/