[PATCH -next v2 2/2] smsc911x: Ignore error return from device_get_phy_mode()

From: Guenter Roeck
Date: Wed Aug 26 2015 - 16:20:55 EST


Commit 62ee783bf1f8 ("smsc911x: Fix crash seen if neither ACPI nor OF is
configured or used") introduces an error check for the return value from
device_get_phy_mode() and bails out if there is an error. Unfortunately,
there are configurations where no phy is configured. Those configurations
now fail.

To fix the problem, accept error returns from device_get_phy_mode(),
and use the return value from device_property_read_u32() to determine
if there is a suitable firmware interface to read the configuration.

Fixes: 62ee783bf1f8 ("smsc911x: Fix crash seen if neither ACPI nor OF is configured or used")
Signed-off-by: Guenter Roeck <linux@xxxxxxxxxxxx>
---
v2: Dropped RFC
Removed check for -ENODATA
Depends on patch 1/2

Tested with non-devicetree configuration. Should be tested with ACPI
and FDT configurations.

drivers/net/ethernet/smsc/smsc911x.c | 14 ++++++++------
1 file changed, 8 insertions(+), 6 deletions(-)

diff --git a/drivers/net/ethernet/smsc/smsc911x.c b/drivers/net/ethernet/smsc/smsc911x.c
index 6eef3251d833..c8b26259c9cf 100644
--- a/drivers/net/ethernet/smsc/smsc911x.c
+++ b/drivers/net/ethernet/smsc/smsc911x.c
@@ -2369,23 +2369,25 @@ static int smsc911x_probe_config(struct smsc911x_platform_config *config,
{
int phy_interface;
u32 width = 0;
+ int err;

phy_interface = device_get_phy_mode(dev);
if (phy_interface < 0)
- return phy_interface;
-
+ phy_interface = PHY_INTERFACE_MODE_NA;
config->phy_interface = phy_interface;

device_get_mac_address(dev, config->mac, ETH_ALEN);

- device_property_read_u32(dev, "reg-shift", &config->shift);
-
- device_property_read_u32(dev, "reg-io-width", &width);
- if (width == 4)
+ err = device_property_read_u32(dev, "reg-io-width", &width);
+ if (err == -ENXIO)
+ return err;
+ if (!err && width == 4)
config->flags |= SMSC911X_USE_32BIT;
else
config->flags |= SMSC911X_USE_16BIT;

+ device_property_read_u32(dev, "reg-shift", &config->shift);
+
if (device_property_present(dev, "smsc,irq-active-high"))
config->irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_HIGH;

--
2.1.4

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/